Question about Two-Way Radios

1 Answer

Need power plugs for a TS-50S and an AT-50

Bought the TS-50S and AT-50 and discovered they came without power plugs. Is there a generic plug that will fit these (I suspect so) and if so who is the manufacturer and part nunbers?

Thanks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 52 Answers

Check http://www.aesham.com/
They can help you !

Posted on Mar 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Positive shift ts 811


Hi,

TS 811, are we talking Kenwood, Uniden, Trident?

We need thr radio Make/Model before we can advise you, you've given a model only, however, this can be generic without the make of the radio.

Please reply with full details, so we can advise you.

Cheers,
Peter

Jan 31, 2013 | Two-Way Radios

1 Answer

What is H and L push to talk?


You do not mention the type of Motorola radio so these comments will be generic in nature:

You need to have your radio turned off when plugging in a headset or audio device. Then press the PTT once after turning on the radio. This should aclimate the headset to the radio. If you were to plug in the headset with the radio turned on, it will appear to be in VOX. But will be stuck with the Transmit side open.

Your H and L PTTs are likely a high power 1-2 watts and a low power one half watt setting. Without the radio model and user guide, we cannot research this further.

Best regards.

Oct 15, 2012 | Motorola Walkie Talkie 2-Way Radio

1 Answer

My TS-140S is only putting out 20 watts. Is there


Coud be burned one of the power output transistors or perhap the polarization source. 73's Edgardo LU1-AR

Mar 03, 2010 | Two-Way Radios

1 Answer

How to increase power output on TS-140s


You can increase the power supply to 15 Volts, but your rig is small to dissipate the cold air inside. Place a small fan in the rear. You not need more power and the difference is barely disguisable to the other part. Put your effort in a batter antenna. Regards. Edgardo LU1-AR

Feb 21, 2010 | Two-Way Radios

1 Answer

Front panel turns off


Have you performed a FULL reset on the TS-2000?
To perform a full reset:

With the power off press and hold down the A=B button and with the other hand turn on the TS-2000.
After that you will have to press the A=B one more time. The radio will reset itself,
and the display will show 14.000 MHz in the main band, and 144.000 MHz in the sub band.

Please let me know if it worked for you.
Tommy
KG4TDM @ arrl .net



Sep 12, 2009 | Kenwood Radio TK 260 360 270 370 2100 3100...

6 Answers

Kenwood TS 2000X: Low HF TX power output on HF bands ONLY.


Hello, this problem is solved and how?
I have the same problem on HF and VHF 30Watt max output

1.8 MHz-20M 0-5Watt
10M 25 Watt
6M-30Watt

2M-25Watt

70cm 42Watt is ok
23cm 10Watt is ok

thanks

Tuxon7@gmail.com

Jun 12, 2009 | Two-Way Radios

1 Answer

Power cord for a TS-50S and also a tuner control cable


Hi crowdisr,
your best bet is trade me, and have you tried the agents?
regards John

Apr 26, 2009 | Two-Way Radios

1 Answer

Remote control cable


Within the same manual, you'll find a section that may say: Additional Accessories.
The cable should be listed as an accessory item to order.
Contact Kenwood and ask them how to order the cable.

Oct 22, 2008 | Two-Way Radios

3 Answers

Kenwood ts-450s - cannot tune and no ptt


This is usually due to a stuck or shorted ptt line. I have repaired a couple of these and it was the same component each time. The packet TX transistor Q65 shorted causing the radio to power up in TX inhibit mode. Transistor Q65 is located on the underside of the IF board under the ACC 2 connector. This switching transistor is used only for tx (pin 9 of acc 2) and no other circuits depend on it. It can be removed completely if you don't mind not having ptt on acc 2.
This seems to be a common problem lately, I hope this helps you.

Apr 26, 2008 | Two-Way Radios

Not finding what you are looking for?
Two-Way Radios Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Two-Way Radios Experts

eradiostore
eradiostore

Level 3 Expert

1640 Answers

Iron
Iron

Level 3 Expert

3018 Answers

Steve

Level 3 Expert

3287 Answers

Are you a Two-Way Radio Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...