What is the required rough in dimension? I am replacing it

1. Use a microwave mounting kit specifically designed for truck cabs. These kits typically include brackets and hardware to secure the microwave in place. They may also include vibration dampening materials to help protect the microwave from the rough ride of the truck.
2. Build a custom mounting bracket using metal straps or brackets. This will require measuring the dimensions of the microwave and the available space in the center locker above the dash. Cut and bend the metal straps to fit around the microwave and then attach the straps to the cabinet using screws or bolts

You need three dimensions for a volume.
30 inches by 25 inches is 750 square inches or about 5.21 square feet.

Reference your pressure gauge as the 12:00 position. Going clockwise-
12:00 is Filter, normal running position
2:00 is Waste, water goes from pool and exits the waste line, bypassing filter.
4:00 is Closed, used only when servicing equipment
6:00 is Backwash, reverses water through the filter and goes out the waste line.
8:00 is Recirculate, water bypasses filter and returns to pool.
10:00 is Rinse, water goes through filter and exits to waste line, used briefly after backwashing to clear sediment from filter.
Note that the "pointer," not the handle that you grab, indicates which setting you are on.

Well the rough-in of the wc is the measurement from the wall to the center of the drain opening take that measurement and go to your local plumbing warehouse and ask them to look up any and all wc with that rough-in and pick one you like. If there are non you like or there is non with that rough-in then I see no other way then to move the drain to fit the one you like.
There are some offset closet collars out there but if you are working a cement for it would be just as easy to move the drain.

Those two are error codes, and they mean the following:

E8 - The waste ink absorber is almost full. Press the OK button to clear the error.
Printing can be done until the waste ink absorber becomes full. If the waste ink absorber becomes full, please contact your local Service Center for replacement of the absorber and machine maintenance.
The waste ink absorber is a part inside the machine, which absorbs ink used in the cleaning operations, etc.

E27 - Manual does not specify what this means, but tells you what you should do: Turn the machine off, and remove the power plug from the outlet. About ten minutes later, plug it in again, and turn the machine on. If the problem is not resolved, the machine may require servicing. Please contact your local Service Center.
You can read more about the error codes on Canon website.

That is a rough in dimension.If you make it to close ,it will make it hard to connect the flex line,and may end up kinking the linethen you'll have poor or no water flow to the ballcock

You may have a problem with you video on motherboard.
Try removeing the memory and reseating.

Ther is a cotton sponge under the ink well that is full of ink. It needs to be replaced. If you are mechanically inclined, you can replace it.

Hi,

The Asus P5PKL motherboard has the dimensions of 12 X 7.6 inches.

The boards which exactly match your size requirements i.e; 9.6 x 9.6 inches are:
Asus P5P800-VM and Asus P5P800-MX

You can also have a look at Asus P5KPL-CM , P5KPL-VM, P5KPL-AM motherboards which have the dimensions of 9.6 x 8 inches.

Hope this solves your problem Thanks.

You Have to Clean a litle square reflexive patch that is located on the IBT Belt.
Just remove the waste developer botle, turn the orange handle CCW, remove the 2 external screws of the IBT Assy and pull out the Transport drawer and IBT drawer. clean the patch reinstall and thats it.