Question about Williams 2509612 Ceramic Mid-Size Heater

2 Answers

Copper Charmglow Heater will light but only stay on 5-10 min

New tank, lights OK but won't stay on more than 10 MIN

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The problem is a bad O2 sensor, detects low O2 and it shuts the heater down, just replace the sensor and it should work fine

Posted on May 17, 2013

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Try purging all the air from the tank.

Posted on Mar 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My mr heater wont stay light unless its above 3. It only stays on about 5 min then pilot goes out. It is gas heater. What's wrong with my heater?


Theres a thermostat inside, if its too cold and not warming up the thermostat enough it will shut off because it thinks there is a problem.

Feb 07, 2013 | Heating & Cooling

1 Answer

I have Dayton space heater 3E 229, pilot wont stay on,I have install new gas operating valve and checked transformer ( 30V) . Pilot lights up but wont stay on even if I hold button down for 2-3 min. please...


The thermocouple is likely defective...(Copper wire heated by the pilot) or the pilot itself is too small or dirty....the pilot must be BLUE , not yellow like a candle...and it must envelop the top portion of the thermocouple....you could also have an auxiliary limit or ECO wired in series with the thermocouple circuit that could be open.....also make sure the thermocouple is inserted all the way and is in the pilot flame as mentioned above

Oct 25, 2009 | Dayton Gas Furnace Heater

1 Answer

Burner on Charmglow patio heater will not stay on.


believe it or not, the propane tank may be too full. The vapor space is taken up and you have very little vapor. Run some warm water over the tank. The garden hose may be enough but if you get no frost line the water will need to be warmer. The warm water causes the liquid fuel to turn into vapor. Do not use boiling hot water. Another thing is oening the valve. Most propane tanks have safety valves. If the gas escapes faster than a normal rate, the valve closes. Open the valve slowlyand lt it burn for about 10 minutes before opening the valve further. It will get better as the fuel is used up and the vapor space in the tank increases. In real cold climates a heater blanket, sleeve is used tho keep the bottle warm. The vapor also creates the the needed pressure to move the gas through the system to the burners. Good Luck-Ned_

Sep 15, 2009 | Williams 2509612 Ceramic Mid-Size Heater

1 Answer

CHARMGLOW PATIO HEATER WON'T STAY ON


Probably a venting problem! Can be very difficult to diagnose and repair'

Mar 09, 2009 | Williams 2509612 Ceramic Mid-Size Heater

2 Answers

Charmglow patio heater


Looks like the knob or the contacts are faulty.

Nov 07, 2008 | Williams 2509612 Ceramic Mid-Size Heater

2 Answers

Charmglow patio heater


Well, I just went out this morning and worked on the heater after it would not light last night. Turns out that a spider or moth set up camp in the pilot light intake housing and plugged up the two small mixer holes that pull in air for the pilot light. This would explain the 'yellow-flame'. I took a punch awl and some compressed air and cleaned out the hole, then re-installed the cover and knob. Lastly, I turned and depressed the knob and the pilot light ignited almost instantly, stayed on when I let the knob up, and the heater turned on normally after that. Good luck, I hope this helps.

Oct 20, 2008 | Williams 2509612 Ceramic Mid-Size Heater

1 Answer

Patio heater keeps shutting off


Returned it to Home Depot, paid $50 for upgrade to "better" unit.

Sep 28, 2008 | Coleman (5040B750) Patio Heater

2 Answers

Outdoor patio heater won't stay lit


I'm told by Charmglow that the problem is the Thermocouple. iHowever,it took me several calls to get someone to admit this. They are sending a new thermocoupler. My heater is less than a year old and under warranty--but it's a shame things like this happen.

Originally I was told it could'nt be the thermocoupler as they normally last at least 5 years.

Try it--as it may solve your problem as well.

Sep 21, 2008 | Heating & Cooling

3 Answers

Charmglow gas patio heater


My charmglow heater is a yeAr old and the pilot will ignite and stay lit for ever,but when you let up on it it goes out! What cam I do?

Mar 16, 2008 | Coleman (5040B750) Patio Heater

Not finding what you are looking for?
Williams 2509612 Ceramic Mid-Size Heater Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Williams Heating & Cooling Experts

paulcarew

Level 3 Expert

2059 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Superior Maintenance

Level 2 Expert

63 Answers

Are you a Williams Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...