Machine only as 2850 operating hours on it. Technician came in, opened door, spun drum and proclaimed that its the "aluminum plate attached to the back of the drum. It's cracked because You used too much soap and because of calcium buildup." He wants to take it back to Miele and it's $1000. To fix it. I've only ever used Persil soap (1/4 cup) and our water is softened. Also, the Miele literature says that these machines should usually run for 7-10 loads a week for about 14 years. The spinning is so smooth, there isn't anything clanking around inside. Could it be something else? Could he actually know what the problem is without opening up the back and having a look?
SOURCE: Help ! I own a Miele Touchtronic W1113. I put to
Hi,
Sounds like you may have flooded the base of the unit and activated the float switch. Tip the unit forward slightly with a towel at the base and all the water will pour out. You should be right to run the unit after that and any other water inside will dry up. it won't rust as it is stainless steel inside.
SOURCE: Hi, i have a miele novotronic w 916 and it's not spinning
I mean this is not a filter error and i think the power main board inside on front bottom EL110 has an defekt and must change.
Or you can post the problem on my board www.avpc.de with photos for solving together and find another cheap used power board for it ...
SOURCE: How do I use the washing machine, a miele novotronic w 969
Hi,
The I is the pre-wash and the III is the main wash where you put the soap powder. the # star looking symbol is the fabric conditioner.
If you don't have a manual you can download this from the miele website.
Testimonial: "Thanx for the help. I managed to get my first wash very successfully. "
SOURCE: washing machine not spinning
I had a similar problem and about a week later it didn't wash at all.
Turned out the water inlet valve (one of the three) was faulty. The rubber seal/seat had a small hole and wouldn't open to allow water into the machine.
I wasn't prepared to pay the $213 for a new one so I went to our local appliance spares place and found one that was similar and used the rubber seal/seat from that to replace it. It was an electrolux single inlet valve part #360313 (from memory). Cost me $37. Could've got it for $22 delivered off ebay but I needed it asap.
SOURCE: 10 year old miele 300 washing machine jumps to
Most likely brushes. Fit carbon brushes part no.4297411 as they are less then half the price of the brush module Part no. 4229779.
542 views
Usually answered in minutes!
×