Toshiba e-studio 2830c Will not power up

To obtain firmware for your Toshiba e-Studio 2830c, you can follow these steps:

1. Visit the Toshiba website and navigate to the Support section.
2. Enter the model number of your printer in the search bar and click on the search button.
3. On the search results page, look for the Downloads or Firmware section.
4. Select the firmware version that is compatible with your printer and operating system.
5. Read and accept the terms and conditions of the download, if prompted.
6. Download the firmware file to your computer.
7. Follow the instructions provided by Toshiba to install the firmware on your printer.

It's important to make sure that you are downloading the correct firmware for your specific printer model and operating system to avoid any compatibility issues or other problems.

i cant find a listing for the studio 305 waste toner bottle
Toshiba STUDIO 305 Toner Cartridges

this is the 3055c
Toshiba STUDIO 3055C Waste Toner Containers

plenty of other studio models have listings
Toshiba STUDIO 2830C Waste Toner Container Genuine B6241

There are many possibles that can cause "Close Front Cover"
Check the front cover actuator, switch. If all covers, switches is working fine, probably power supply is faulty.

Toshiba e-STUDIO 2330c
Is given error message "Close Front Cover". The front cover is closed and I can not get error message to go away.
Where can I buy Power Supply (6LG03347000)

Waste toner transport motor drive locking error.

Toshiba Copier Error code c 970 problem solution help: Toshiba E STUDIO 2330C, Toshiba E STUDIO 2500C, Toshiba E STUDIO 2820C, Toshiba E STUDIO 2830C, Toshiba E STUDIO 3500C, 3510C, Toshiba E STUDIO 4520C

PROBLEM:
1.The charger wire at the side door is broken. :(" title="Angry">
2. The charge wire is vibrating. :(" title="Angry">
3. Main charger grid could be deformed. :(" title="Angry">
4. Broken T/S wire. :(" title="Angry">
5. High voltage transformer abnormaility. :(" title="Angry">

Solution:
1. Check if any foreign objects are on the charger wire.
2. Check and clean your main charger grid .
3. Replace the wire and the grid.
4. Check if the spring of the high-voltage supply contact point is deformed.

Double check your printer driver.

off the machine press 0 and 8 at the same time and power on AJ mode appears on the panel..press 388 then start 389 and start off the machine ..then power on

The problem is this :
Thermistor or heater abnormality at power-ON: Abnormality of service call the thermistor is detected when power is turned ON or the temperature of the fuser roller does not rise in a specified period of time after power is turned ON.

the solution is to change thermistors

Date:06/04/2013Sir
My digital copier toshiba 181 showing page counting 179113 but when doing copy the previous reading is not increasing , it is stopped in 179113. could you give me suggestion to(Programe) reactivate the page counting.
Thanks
Golam Rabbani
Chittagong, Bangladesh