How to conect led pow cables to scaleo motherboard

this is the download page for the motherboard manual http://www.biostar.com.tw/app/en/mb/introduction.php?S_ID=363&tab=1 it is in Zip file form you want the front panel pinout if you are having a tough time reading this it is because i didn't use any periods or capitalization bu i guess you are used to it

According to Fujitsu Service Support, the Scaleo 600 uses a Gigabyte GISXT
mobo. (MOtherBOard)

http://uk.ts.fujitsu.com/rl/servicesupport/techsupport/consumer/MediaCenter/Scaleo%20600/Scaleo%20600.htm

(Actually the Gigabyte GISXT-FS motherboard.
G - 'eye' - SXT)

This is the PDF download, for the Gigabyte GISXT-FS motherboard manual,

http://uk.ts.fujitsu.com/rl/servicesupport/techsupport/Boards/Motherboards/GigaByte/ga-8isxt/Man_8isxt-fs_uk.pdf

go to intel under support down load manual ok look at the front pannel

Check the VGA cable first

mybe something wrong with your hardisk or Motherboards.you can sheck with manually open the case and try to reconect and conect again the cable.

is the cable a crossover cable

You need a "crossover lan cable" to conect PC to PC

A "lan cable" is for networks

there is a small writen name embeded on every board,
rst=reset
pwr=pow

most of the time, those connections are on the bottom-right of the motherboard. Look carefully for markings or words.

Most often its like this
reset HDD POW
o o o o o o o o
o o o o o o o o
PW/SW

or somtimes its above like this


reset hdd pow
pw/sw

o o o o o o
o o o o o o

LOOK AT THE MARKINGS. HOOKING IT UP WRONG MAY CAUSE PROBLEMS

hookups are usually like this


o o o o o o
o o o o [o o]
PW/SW
hope this helps

hi bob i need to know the motherboard's serial number then shouldn't be a problem finding the service manual for it with all the information you require some motherboards got that information imprinted near the pins if you look close enough