Question about Computers & Internet

1 Answer

How to open the lap top case of a MPC T2000

Need to get at the power receptical for repair

Posted by on

  • twiseman2 May 11, 2010

    What brand laptop?
    You have to be care when replacing the power plug, if not done correctly it can short out causing an electrical shock situation.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Witha screw driver

Posted on Mar 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gemstar 15" monitor/GM 171-B powers up but nothing on screen


You may have either the DC filter caps problem or the back light inverter board has failed, worst case will be bad lamps assembly. So check for 12vdc on the inverter board, bad caps with leaking/bulging top, bad solder joints.
Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, blown fuses, poor solder joints, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://en.wikipedia.org/wiki/Capacitor_plague

Jun 29, 2010 | MPC Computers MPC F1760I 17" FLAT PANEL...

1 Answer

Operating systems not found


Unfortunately, it sounds like your hard drive probably went bad.

Jun 16, 2010 | MPC Computers TransPort T2000 Notebook

1 Answer

I cannot remember my Bios start up Password on my Panasonic Lap Top CF-R6


you can reset passw, but reset bios to defaults, need to enter time and date.

Note: disconect power, and release battery module.

you need to open laptop case, for these:

1st : check for screws below laptop, with keyboard label, take them out. check for plastic cover on keyboard (top), and take this out, (very carfully is very fragile).
then take the keyboard out (check for small fragile plastic cables).
look inside for any battery (module or big/small clock battery inside).
try to reach , and take this out ( connector or battery) , if dont see-it you may need to open all laptop bottom case. take all bottom screws and open carfuly the case, ( 1st take the memory, hd, cd drive, and so on. Out) and check where is the battery is located. and take very carfully on removing boards and so, is very fragile boards.

then remove battery out, wait a 1min and then reaseable all again, in the same order and same screws positions. and your problem is repaired. when power up. you need to enter bios to configure date and time. and reboot to test.

Jan 02, 2010 | Panasonic Toughbook CF-51 Notebook

1 Answer

Floppy drive a, where? how to open it


Unfortunately there is no floppy drive present in the Notebook. But when you install Windows XP the Icon " 3 1/2 Floppy (A:)" will be located in My Computer. But actually there will be no floppy drive present. There is no need to panic for that, just leave it. Thank you for contacting Fixya.

Nov 14, 2009 | MPC Computers TransPort T2000 Notebook

1 Answer

When I push the power button on my MPC t2000 laptop the fans come on and cdrom spins up but the bios does not show up nor the hard drive spin up


go to setup and see if the hard drive shows on it if not may be out. try to start on safe mode and see whaat happen

Nov 08, 2009 | MPC Computers TransPort T2000 Notebook

1 Answer

Need to remove bios password


You will have to reset the BIOS to the default settings.
Power OFF the laptop, remove the power supply and battery.
Open the access door and either:
1. Remove the motherboard battery for a few minutes and put back in.
2. Locate the two reset pins nesr the CMOS BIOS chip or near the motherboard battery. Shot the two pins for a few seconds.

Close 'er up, replace main battery and/or power supply.
*done*

Oct 02, 2009 | MPC Computers TransPort T2000 Notebook

1 Answer

Having problem installing the wireless driver on transport T2000


If you can't install the driver for the wireless,it can't turn on.You also should make sure, its the correct driver for the wireless card you have under your keyboard.Several other wireless cards, can and could be connected to your motherboard ,other than the one from MPC.If you want you can contact.me at(durtopian @hotmail.com) with more details of your problem and i'll help you more,if i can.

Sep 25, 2009 | MPC Computers TransPort T2000 Notebook

2 Answers

How do I remove the back of my MPC Transport T2000?


You have to first remove the hinge covers then remove the power strip where the power button is then remove the hinge screws then unplug the display from the motherboard turn the laptop over and remove all the screws there.Turn it back over remove the keyboard.Then remove both wireless card antenna wires that run up to the display.then lift the display off and lay it to the side.remove the cd drive.Then carefully pry apart the top from the bottom slowly and you should then be able to have access to the motherboard and other internal componants.

Aug 29, 2009 | MPC Computers TransPort T2000 Notebook

1 Answer

My lap top is in power save and my moude and


Hold the power button down until the Laptop shuts off completely and then pull the battery out for 30 seconds as well as the AC adapter.

Replace the battery and boot the Laptop

Jul 21, 2009 | MPC Computers ClientPro 365 PC Desktop

1 Answer

Wireless network


I don't think Vista has a working driver for the T2000 because it was designed for XP..Unless you upgraded the XP you had to Vista.You should install XP back on the laptop then go to (www.mpcdrivers.com)where you can get the exact drivers for your base unit and the XP operating system.Putting XP back on it, is really the only sensible thing to do, to ensure all hardware will be installed ,especially the biometrics.Thanks

Jan 12, 2009 | MPC Computers TransPort T2000 Notebook

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Computers & Internet Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

kakima

Level 3 Expert

100140 Answers

David Payne
David Payne

Level 3 Expert

14160 Answers

Are you a Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...