Question about Freezers

1 Answer

I have a Whirlpool side by side fridge freezer (brand new only 2 days old) the alarm is going off and the two lines side by side on the freezer side are flashing?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 400 Answers

The alarm is set off when the freezer is out of the differential range of the setpoint. In other words, the freezer is still too warm. If you press the alarm button, the sound will stop but the light will stay on. If the unit is working correctly and cooling properly, this light should go out once the cabinet temperature gets close to the setpoint temperature. Hope this helps you.

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

True T-49 refrigerator/freezer temperature calibration


Contact the manufacture, it is most likely going to be covered under warranty. If the knob is not removable, (check for a set screw on the side of the knob it will take a small allen wrench) Then the thermostat (temp controller) will need to be replaced, if it isn't a style that you can calibrate.

Jan 30, 2014 | True Refrigeration True T-49 2 Door Bottom...

1 Answer

Exterior door presents condensation (a vertical line in the middle)


Normally when there is insufficient air flow in the room the freezer door will condensate and show wet spots.Have that often when testing a fridge in the workshop. Once the door is wide open, the wetness on the door goes away.

Dec 14, 2012 | Whirlpool 19.6 cu. ft. Upright Freezer...

1 Answer

Hi, i have a whirlpool american style fridge that beeps etc.


its the compresor packed up,,,if this compresor is not pumping freezer gas around the pipe work the freezer wont work sorry but a new compresor is not a cheep thing to have fitted as it will need a re-gas as well

Jun 29, 2010 | Freezers

2 Answers

Westinghouse fridge freezer alarms keep going off


Try a different web site, where are the solutions on this one????? Great site..... not

Dec 30, 2009 | Freezers

2 Answers

Whirlpool fridge freezer alarm s20D RSB33AG-B


Hi, you have a common problem with your control boards; there is a cheap fix if you can use a soldering iron or you can have your modules repaired.
Let me know

bb

Aug 31, 2009 | Whirlpool Freezers

1 Answer

Filter changed but still 1% on display panel


Is this a side by side fridge freezer? Most Whirlpool models with LCD display on front- reset filter indicator to display 99% by pressing and holding 'OK' button until filter resets to 99%. If you have a different model, or of this doesn't work, advise on model number and I can instruct further

Aug 10, 2009 | Whirlpool Freezers

1 Answer

Fridge not getting cold


you have a defrost problem.when you open your freezer door and look at the back panel look and see if their is frost built up.if so that means you do have a defrost problem.you will need to pull panel off and defrost coils.then you can check your defrost thermostat which is round and has 2 wires that go to it.it sits at the top of coils.see if it seperated.if so that is your problem also check defrost heater see if any breaks in it.if those check out then could be defrost timer which is located in ref.side.it would help to know what brand it is.it sounds like a side by side ref,but dont know what brand.

Mar 24, 2009 | Freezers

1 Answer

13 months old Kenmore compressor very hot.


lacdoi,
huuum At your service!

You said,
The warranty just ran out, Sears came out told me needs a control board ($210 for just labor to replace) not sure about part price. I though a new freezer is about twice his labor and parts, so I sent him away minus $65.
I did some troubleshooting today, pull the plug for 2 days. Plug it in, temp alarm goes on all the time. Turn alarm off, left the freezer running for 4hrs.
Not cold at all, some cool air. Fan is on, compressor is on (can hear humming noise and is vibrating). Compressor is very hot to the touch, could burn finger.
Should I call Sears again, wonder how much to fix all the problem? Or just give up, look for another brand new one (not Kenmore).

MY ADVICE:
Sounds like a big repair bill and multiple problems

How old is the appliance?

If the appliance is 10 years old or more you may not be advisable to put good money into bad!
New appliance are so much more efficient today that they can save you a lot of money in energy!!!!
Replace it.


You will be fine

Bless You huuum

Please give me the best rating for my fine advice before you sign off.
Thank you

Sep 17, 2008 | Kenmore 20.3 cu. ft. / 575 liter Upright...

1 Answer

Whirlpool FRS Side by Side Fridge Freezer


Hi Simon I saw that problem because you have a hole in the bottom of the freezer connecting directly on the wall of the fridge you need to block it ... because the air flow directly from the freezer 2 the fridge . Hope it was helpful.

Francois

Aug 01, 2008 | Whirlpool Freezers

1 Answer

Whirlpool fridge freezer (american style)


you have a bad control or bad sensor

May 11, 2008 | Freezers

Not finding what you are looking for?
Freezers Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Freezers Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

AJMAL KHAN

Level 2 Expert

382 Answers

Victor Nwachukwu
Victor Nwachukwu

Level 2 Expert

152 Answers

Are you a Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...