Question about RCA HD52W58 52" TV

1 Answer

Anyone know why the picture would shake slightly

Hi- I was wondering if anyone would know why a large screen tv would have a problem with the picture shaking for a duration on 20-30 sec every 5 min or so. thanks alot Jason Tv, edges are shaky and the colour is kind of lighty flickering. Don't know what is causing it,,, it happened in the middle of playing Fallout 3, and it is on EVERY channel (including AV1 / AV2...) I don't exactly have the same problem, but when I play fallout 3 on my RCA 52" HD52W58 TV it will completely black out. When it first started happening it would take about 20 minutes to screw up, now it happens as soon as start playing.

Posted by on

  • Anonymous Mar 16, 2014

    Noticed that the picture is slight rotated about 10% clockwise. Wondering why this is happening and can it be corrected

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Does this tv have hdmi input and if so does the problem exist there?
If so I suspect the av input board could have a problem.

Posted on Mar 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No picture


your sony ctv is in sleepmode. so kindly press sleep button at remote control .other wise you swith off tv ( that means remove the mains wire from pluck point) then after 5 minutes switch on it will OK.

Aug 02, 2010 | Sony FD Trinitron WEGA KV-32FS120 32" TV

1 Answer

Picture is slightly tilted


Its an easy adjustment but it requires you to work around the deflection yoke on the neck of the picture tube. Above the yoke is a red connector that is carrying 30,000 volts then on the yoke itself you have wires that are connected to the horizontal and vertical circuits that can carry up to a 1200 volt pulse. So this alignment is not for anyone but a technician. I personally would leave the tilt until you can have a technician touch it up for you. Take a moment to rate my answer. Thanks...

Nov 20, 2009 | JVC AV-32FA54 32" TV

1 Answer

Does anyone know were to get instruction manual IQ3557CC


I am not sure which TV you have. You can get an operator manual from;

http://www.retrevo.com/support/Zenith-IQA36M46W-TVs-manual/id/277ci277/t/2/

for a large TV. Click on the "Get Manual" icon for download. The menu will probably be a close match.

Mar 27, 2009 | Zenith Standard (CRT) Televisions

1 Answer

Slightly slanted screen/picture


your main filter capacitor in power supply has gone defective.

just replace it .

every thing will be normal.

good luck.

 

Oct 17, 2007 | Toshiba 36AF43 36" TV

1 Answer

Toshiba 36A50 problem with horizontal lines at the bottom of TV...


you'll need to replace bad capacitors on the vertical circuit stage , no expensive but you need the basic knowledge, and the tools to do it your self , if not . you need a tech depend on the tech 60 to 80 dls a shop 125

Jun 10, 2007 | Toshiba 36A50 36" TV

1 Answer

SONY KP-46S25


A "Gray Scale" adjustment may solve you problem. If one of the picture tubes is set too high it will cause these RETRACE lines. Then too a weak picture tube might cause this. If the horizontal lines are one color: red, green,or blue then whichever color that is shown would tell you which tube is set too high. Your set has 3 screen controls that control the brightness of each tube. One may need to be turned down a little. Stargazer

Mar 11, 2007 | Sony KP-46S25 TV

1 Answer

Sound, but no picture


Locate vertical output IC = solder all pins = two off-set rows,
then try again................part location IC301 , or 401 ?

2) possible bad CRT = turn up screen voltage slightly = did pix pop back on ?..................................T.

Please rate this solution.........................

Feb 09, 2007 | Sony KV-27V22 TV

1 Answer

How to manually adjust the centering of the picture


On newer televisions the centering adjustment is only in the service menu. I wouldn't suggest anyone accessing it unless you understand all of the abbriviated alignments.

Feb 21, 2007 | Samsung TX-R2035 TV

1 Answer

Help: My tv picture has started going blurry


The picture tube is going bad,not worth repairing,better invest in a new set. The rating response is important to the person helping you.

Oct 11, 2006 | Samsung TXN2734 27" TV

2 Answers

RCA 27R410T


hi Sounds like a dry solder joint on or near the flyback try here: http://www.eserviceinfo.com/ good luck windman

Mar 04, 2006 | RCA 27R410T 27" TV

Not finding what you are looking for?
RCA HD52W58 52" TV Logo

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68223 Answers

John mullen

Level 2 Expert

245 Answers

gbob59

Level 3 Expert

2963 Answers

Are you a RCA Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...