Remote control codes

Try using code search. If a search through all codes stored in your Dish remote control fails, you may have to try a different universal remote control.

The dish remotes only have a limited number of codes, if not there remember not all remotes will program all sets....

Not likely the Dish remote will have that remote code at all in it--some of those sets were made by Samsung so try those codes also.

Remote Codes ' MyDISH ' DISH Customer Support

https://www.mydish.com/support/remotecodes

Remote Control Manuals · Program Remote to TV/Other .... remote, product type, and manufacturer below to see the current known remote codes you should try.

My Dish remote needs programming for Sanyo TV ... - Directly

https://www.directly.com/.../dish-network-my-dish-remote-needs-progra...

My Dish remote needs programming for Sanyo TV, Model DP226649. My Dish ... Needcode. Alta asked this ... Dish Network • 16808 answers • 95% helpful. Code is ... Test volume control, if it works you're set ... try 590 it should work. tivosat.

How do I program my dish remote to work for my Sanyo TV.

https://www.directly.com/.../dish-network-how-do-i-program-my-dish-re...

Dish Network. How do I program my dish remote to work for my Sanyo TV. ... entercode 590 press pound then sat Then try to turn tv on and off then try volume.

How do you program a dish network remote to my sanyo tv? ' Ya

Hello
Haier is not listed with URC22B-15 universal remote control. Anyway, check with these four digit codes reported to be of Haier. Wish you Good Luck.
0081 0216 0217 0157
OK.

Hi my name is Mike Houston of DISH Network and I was going over yourpost and see you want to program the universal remote to the DISH Networkreceiver. To be able to get the full use of the receiver it is better if youhave the DISH remote, I will leave you my e-mail address if you have anyquestions about getting the remote that goes with the system. michael.houston@dishnetwork.com

few universal remotes have a code to control the gateway tv. check with manufacturer of remote to see if they have an off code that may work, or check out universal remotes from gatway that can control you cable box. sorry, there isn't much else to do on that.

Cable and Satellite content providers control the remote codes,
and we apologize for any confusion during the remote programming.
Please try the following codes 10019, 0178, 10178, 0030, 10030,
0835, 10835, or for Dish Network try 627, 659 or 505. For Fios
TV (Verizon), try the code 3264. These codes may not work on some
universal remotes. If there is another code listed for Element
Electronics in your universal remote control guide, please try that
code. Refer to the Remote Control Guide under your TV’s model
number for more information.

My solution was to buy a one for all universal remote that is upgradable . The model is urc6131n
from ambientweather.com for $9.98. You will have to send the remote in for the upgrade to one for
all. It will control your Magnavox tv and Dish receiver.

The GE Universal Remote will do the job. I have on and it works for my Haier TN201AUV TV. You can also find a replacement Haier remote on Remote Hound's web site.

On the other side of this I have a Dish Network remote that WILL NOT work. The Dish Network remote does not list any codes for Haier. Dish Network Tech Support could offer no help.

In an attempt to solve the problem myself, I looked on-line at GE's site listing all of the manufacturers' for their remotes and found the identical code that worked for my Haier TV also listed under APEX TV's. The Dish Remote lists (11) APEX TV codes. Ironically, NONE OF THEM WORK!

I'm stuck with using both remotes... and that's BULL$H!T