Question about Galaxy Radios DX-949 40-Channels Base CB Radio

1 Answer

It powers up....no modulation ...output power..or receive....just static...galaxy dx 949...

Posted by on

  • bobcat_9988 Mar 03, 2009

    took the back off of it today and guess what....the wire soldered to the coax connector from the board was broke off... soldered it back on and tightened up the connector....and she works! man they must put some tough finals in those radio's..

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 463 Answers

Sounds like the PLL may be toast. Either that, or someone has **** with the wrong potentiometers or tuning slugs in the radio, causing to to no longer resonate on the correct freqs.

Posted on Mar 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is Dead Key on a CB Radio?


Deadkey is slang it is CW or Carrier wave which is RF power produced before modulation/audio is mixed in which stimulates PEP wattage slang being SWING WATTS. A Watt Meter is used to measure it which is often a combination device Wattage/SWR/Modulation meter.

May 08, 2013 | Galaxy Radios DX-949 CB Mob ssb Swr...

2 Answers

I have a galaxy 949 dx that won't talked side band


The antenna system is far better in your home base setup. All things being equal the earth ground will far improve your reception.

Apr 17, 2013 | CB Radios

1 Answer

Hi i have a galaxy dx 949 i loss the recevie what part do i change


Sub another mike becuse it is part of the circuit, audio output ic,"sometimes developes crack on case" check speaker,"opens" and finally check small capacitor near the audio output ic.

Mar 30, 2012 | Galaxy Radios DX-979 40-Channels Base CB...

1 Answer

Trying to find the right size linear amp to hook up to my Galaxy dx 949. I want max in/outputs. tired of being talked over. I have a Golden Eagle 150w amp, but have not connected it


That linear will be good for 100 watts of clean power. It has two MRF455 transistor which are 60 watts a piece. The cb will drive it with the carrier or dead key reduced to about 1.5 to 2 watts but i suggest that you read the linear's power while adjusting dead key not exceeding the 100 watts pep with voice. An NPC mod would be a good addition to get the modulation up with a low dead key.

Before you start the projection make sure you antenna system is in good condition high SWR will smake you linear in a hurry.

In factory condition 949 galaxy with a 3.8 carrier it will drive a 667v TexasStar. It is a low drive linear that will end all disputes as to who has more power. 8 out of 10 birds that escape will die of cancer withiin 72 hrs. Ok could not help myself. I would not suggest that unless you just want to damage other peoples receive. The v is for variable power. Hope this was of help.

Sep 14, 2011 | CB Radios

2 Answers

How to adjust frequency on transmit??? Galaxy


hELLO THERE
hERE IS SOME MODIFICATIONS FOR THIS RADIO
Galaxy Mods DX 2527 - VR 1....AM/FM S-Meter, VR 2....SSB S-Meter, VR 3....SSB Squelch Range, VR 4....AM/FM Squelch Range, VR 7....SSB Carrier Balance, VR 8....RF Meter, VR11...Driver Bias, VR12...SSB ALC, VR13...Hi Power, VR14...AMC, VR15...AM Low Power, VR16...SSB Low Power, VC 1....10.240, VC 2....10.240. DX 2517- VR 1....AM/FM S-Meter, VR 2....SSB S-Meter, VR 3....SSB Squelch Range, VR 4....AM/FM Squelch Range, VR 5....FM Deviation, VR 6....SSB Carrier Balance, VR 7....TX Offset, VR 8....CW Beep Level, VR 9....RF Meter, VR10...Final Bias, VR11...Final Bias, VR12...Driver Bias, VR13...SSB ALC, VR14...AM/FM High Power, VR15...AM Modulation Meter, VR16...AM Modulation, VR17...SSB Power, VR18...AM/FM Low Power, VR601..13.8 Volt Power Supply. DX 22B- VR 1....AM/FM S-Meter, VR 2....SSB S-Meter, VR 3....SSB Squelch Range, VR 4....AM/FM Squelch Range, VR 7....SSB Carrier Balance, VR 8....RF Meter, VR11...Driver Bias, VR12...SSB ALC, VR13...High Power, VR14...AMC, VR15...AM Low Power, VR16...SSB Low Power, VR21...TX Offset, VC 1....10.240, VC 2....10.240. DX 11B- VR 1....AM/FM S-Meter, VR 2....SSB/CW S-Meter, VR 3....SSB Squelch Range, VR 4....AM/FM Squelch Range, VR 5.....FM Deviation, VR 7....SSB Carrier Balance, VR 8....RF Meter, VR10...Final Bias, VR11...Driver Bias, VR12...SSB ALC, VR13...AM/FM High Power, VR14...AM Modulation, VR16...CW Tone Level, VR20...Final Bias, VR21...TX Offset, VR601..13.8 Volt Power Supply, VR803..AM/FM Low Power. DX 77HML, DX 88HL, and DX 99V- VR 1....AM/FM S-Meter, VR 2....SSB S-Meter, VR 3....SSB Squelch Range, VR 4....AM/FM Squelch Range, VR 5.....FM Deviation, VR 7....SSB Carrier Balance, VR 8....RF Meter, VR10...Final Bias, VR11...Driver Bias, VR12...SSB ALC, VR13...AM/FM High Power, VR14...AM Modulation, VR16...AM/FM Low Power, VR20...Final Bias, VR21...TX Offset.
Unmarked VR in R189..AM/FM Medium Power for DX 77HML only. DX 33HML, DX 44V, DX 55V, DX 66V, and DX 73V- VR 1....AM/FM S-Meter, VR 4....AM/FM Squelch Range, VR 5.....FM Deviation, VR 8....RF Meter, VR12...Low Power AM Modulation, VR13...AM/FM High Power, VR14...High Power AM Modulation, VR16...AM/FM Low Power.
Unmarked VR in R188..AM/FM Medium Power (DX 33HML only)
Unmarked VR in C139..Med Power AM modulation (DX 33HML only) DX 949,DX 959- VR 1....AM S-Meter, VR 2....SSB S-Meter, VR 3....SSB Squelch Range, VR 4....AM Squelch Range, VR 6.....SSB Carrier Balance, VR 7....TX Offset, VR 9....RF Meter, VR10...Final Bias, VR12...Driver Bias, VR13...SSB ALC, VR14...AM High Power, VR15...AM Modulation Meter, VR16...AM Modulation, VR17...SSB Power, VR18...AM Low Power, VC1....10.240. DX 2517 and DX 2527-
Symptom:Buzzing or motorboating sound in either the transmit or receive.
Problem: TR602 is oscillating
Cure: Replace C602 with a .01uF cap {Cap is located in the power supply board}.
RG 66,99,DX2517 Replace Q54 2SB754 60watt 7A with a higher power 2SB817 100 Watt 12A. Derating of this component will cool operation, provide better voltage stability,decrease wobble, allow voltage increase to 14.5 volts comfortably. (replace 10 volt caps in this section of the radio to a minimum of 16 volts before increasing supply voltage to this level)and provide faster swing rise time, Replace Q37 2SA473 to a 2SA1012-0 or ECG153 this will improve the clarity and volume of the modulation and it will also run a lot cooler.

Nov 12, 2009 | Galaxy Radios DX-949 40-Channels Base CB...

2 Answers

Popping through speaker then no receive sound but signal is their. also lost modulation but output power is their. galaxy 88


most likely you need to replace the mic. and maybe the speaker as well. how can you be sure it does not transmit when noone can answer you since you cannot hear them.

Aug 29, 2009 | Galaxy Radios DX- 88HL Base CB Radio

3 Answers

Galaxy 949 Receive problem


this sounds as the osolator has moved of freq. to check this you need to put it on a scope

Apr 14, 2009 | Galaxy Radios DX-949 40-Channels Base CB...

1 Answer

Powers up, recieves fine, breaksup on transmit Galaxy 949


Check the wiring on the mic plug sounds like you have a loose wire or one thats about to break off.Good luck.....Dan

Apr 01, 2009 | Galaxy Radios DX-949 40-Channels Base CB...

1 Answer

Galaxy 949 mobile CB is off frequency when


a friend of mine just told me he used the galaxy 2517 adjustment procedures. I hope this may help you. Buckeye back quiet.

Mar 03, 2009 | Galaxy Radios DX-949 40-Channels Base CB...

Not finding what you are looking for?
Galaxy Radios DX-949 40-Channels Base CB Radio Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Galaxy Radios CB Radios Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Brad Brown

Level 3 Expert

13531 Answers

Mike Charette

Level 3 Expert

1766 Answers

Are you a Galaxy Radios CB Radio Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...