Question about Whirlpool Cabrio WTW6600SBT Top Load Washer

2 Answers

Loud sounds coming from the washer on spin cycle

When the washer goes into spin cycle it emits a loud roaring noise that can be heard through the whole house. There is also a sound of something slipping while this is happening. This problem has started in the last month or so. The washer is about 2 years old. Any help would be appreciated.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 120 Answers

I have a Maytag Bravos Washer - I have the same problem. It cost as much to change the spin bearing as to buy another washer. Sounds like an airplane landing in my home when it goes on spin cycle.

Remember its whats inside that maters - I will never ever again buy another Maytag!

Posted on Mar 22, 2015

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

That is a characteristic of bearings gone bad. You should look into replacing the bearings.

Posted on Mar 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes our front loading washer to make exceeding loud noise when it enters a spin?


Sounds like a bearing seal is going. The seal has ruptured and grease of seeping out. The loud noise is the bearings rubbing against each other without adequate grease to reduce the friction. Failure will come soon if it is not fixed. The vibration is coming from the friction and possibly damaged ball bearings .

Mar 11, 2015 | Washing Machines

1 Answer

Frigidaire front loading washer has loud spin cycle, Why?


That's a great question, Roth!

Based off the information you have provided your Frigidaire washer is making a loud noise during the spin cycle. This could be an issue with your bel, motor, or tub. In order to find the cause of your noise you may need to disassemble your washer. This is not a simple DIY job and I would recommend contacting a technician to come out. This will help prevent any future issues or personal injuries. -Matt

Mar 11, 2015 | Frigidaire GLTF2940ES Front Load Washer

1 Answer

Kenmore 90 Series washer, won't spin, just loud roar in spin cycle


This site was very helpful to determine problems I had and they have the repair parts. http://www.repairclinic.com/RepairHelp/Washing-Machine-Repair-Help
Washing Machine Repair Help

Apr 28, 2014 | Kenmore Washing Machines

2 Answers

Maytag Top Load Washer MVWB850YW making loud noise in spin cycle.


If it's a roaring noise, the tub bearing is probably wearing out. Spin the tub a little with your hand, if you hear a little of the roar, that's it.

Nov 26, 2013 | Maytag Bravos Series MVWB850YW 28"...

2 Answers

My Whirlpool Cabrio WTW6200SW1; spin cycle loud roar


Hi,
When my washer did that, I found that the shocks that hold the tub were bad...

Check out this tip I wrote about that...

Washer Problems Washer noise when spinning
http://www.fixya.com/support/r3663122-washer_problems_washer_noise_when

heatman101

May 07, 2010 | Washing Machines

1 Answer

Washing machine making loud roaring sound during spin cycle


Very likely the main bearing and drum shaft-inner tub will need replace. Not worth repairing, easily can cost more than the washer. Buy a new whirlpool front load duet, super capacity or the top load whirlpool with and agitator. Good Luck, Appliance Specialists

Feb 16, 2010 | Washing Machines

3 Answers

Loud screeching noise on spin cycle


I have the same problem...during SPIN it make a LOUD SCREECHING sound.

Apr 20, 2009 | Maytag PAV2300 Top Load Washer

1 Answer

Loud noise during spin cycle


is it more like a roar or a train going by? if so your rear tub bearing is going out. very expensive have to replace the tub, basket, spinner ring and shaft and seals about 4 hrs for an exprienced tech to do took me 7 hrs to do for the first time. but it will be very close to $1000 to have done not much less to do it yourself.

Mar 09, 2009 | Washing Machines

1 Answer

Washer


Brake assembly is failing.If the noise is like a loud roar sound,than its not a good idea to fix this.The labor is going to be high.

Apr 29, 2008 | Maytag Performa PAV2200

1 Answer

Spin cycle


  Did it make this noise just when it stopped spinning.  Just for a couple seconds?  If so,  it's only brake noise and not a concern.  If it does this all during spin you probably have a bad tub bearing.  Is it a roaring noise?  This is what the bearing will sound like.  

Oct 28, 2007 | Maytag PAV2300 Top Load Washer

Not finding what you are looking for?
Whirlpool Cabrio WTW6600SBT Top Load Washer Logo

1,705 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...