Jenn air cvgx2423b spark module - Jenn-Air JGC8536 Gas Cooktop

It is possible to use WD-40 to help loosen the nuts, but it may not be enough on its own to remove them. Here are some steps you can try to remove the nuts:

1. Turn off the gas supply to the stovetop and unplug the unit from the electrical outlet.
2. Use a wrench that fits the nut snugly and try turning it counter-clockwise to loosen the nut.
3. If the nut is stuck, try spraying a generous amount of WD-40 onto the threads of the nut and let it sit for a few minutes.
4. After the WD-40 has had a chance to penetrate the threads, try turning the nut again with the wrench.
5. If the nut still won't budge, try gently tapping the wrench handle with a hammer to help loosen the nut.
6. If all else fails, you may need to call a professional technician to remove the nuts safely.

It's important to note that improper removal of the nuts could cause damage to the stovetop or cause a gas leak, which could be dangerous. If you are unsure about how to proceed, it's best to call a qualified technician to help you.

It could be under the top or in the back. Remove the top and look for it there first. Part 18 is what your looking for, good luck.

one thing to be sure is there power to the range. if you can light the burner with a match your gas is good, If all burners are affected it can be a broken wire, power source, or spark module.

always unplug electricity before attempting to repair on any electrical appliance

It is beside the thermocoupler , Buy new one .
Remove old one .
Install new one .

It sounds like you need a new spark module which controls all of the burners. It is part number W10475147. It costs around $115.00!

OK, the best action is to call for service, if the unit was just installed, and purchased. This unit should be covered at this time, by the manufactures warranty, or store 30 day warranty. This repair should be free. The culprit will be a faulty spark ignition switch, and module. Testing is required. Once this switch, or(module), is replaced, the unit will operate correctly.

Hi

Thanks for using FixYa. There are a few things to check for. Make sure the electrode (the small metal piece that the spark comes off from) is clean and the holes in the burner are clean, use a pin or paper clip to clean out the burner holes and not a tooth pick as these can break off and make things worse. Example of a burner. The next thing to check for are the ignition switches under the surface control knobs, the switches can twist and break and keep the spark module on and the spark keeps "clicking" even when the burner is light. If every thing looks good, you may have a bad spark module, replace it.
The switches or the range control knobs may have got wet and are completing the circuit to the spark module thus causing it to continuously click or fire off sparks continuously. Use your hair/blow dryer and blow some hot air around the spark module area.

This is a typical spark module wire diagram--



Please do accept the solution if the issue is resolved or else revert for further assistance.

Thanks
Rylee

check for power by pluging something else in, did it get somthing spilled in it, compressed air blown under knobs removed should doit or just wait for it to dry out are all the burners affected

The module might not sense the flame: check electrical connections: wire (and its contacts0 and conections by fryer chasis; to be sure please bond with 18AWG wire pilot burner with spark module green wire.
MarKor

I have the same model with the same problem. The replacement is simple. Remove the burner cap (no tools needed) Take a large crescent wrench and remove the large center nut holding the burner assembly in place. The ignitor will slide out of the assembly once it is removed. Good luck