RedCat 10e Brushless is faster in reverse than going forward...

Have you checked the fluid level in the left side?

On my 724 I adjusted the cable below the lever on the left side,just loosen the 2 nuts and bring the cable either up or down ,cant remember, I had to fool with it a bit to get where I wanted it, have the blower running and in neutral while adjusting and keep trying her in forward and reverse at full throttle to see after you adjust it, I found that if shes faster in reverse when adjusted she slowed down a bit in forward but keep playing with adjustment till I got it where I wanted it, you have to slow it down going and blowing a lot of snow anyway so didnt mind it a little slower in forward but nice to have it faster in reverse

drive belt -worn loose popped off or damaged ---forward / reverse linkage damaged or disconnected --transport lever engaged --wheel keyway missing ---trans axle pulley damaged --trans axle damaged

likely something has wrapped around the drive capstan, that would make tapes play faster. Forward and reverse are likely belt issues.

Sounds like the motor cables are in reverse at the controller. Check that the red is in the positive and the black wire is in the negative on the controller.

i think you mean forward using left hand, reverse using right hand, if so there should be 1 red and 1 black wire from the motor going to the motor controller if you switch these wires then your throttle should work the way you want but unless there is a speed control pot on the throttle enclosure you may also now run faster in reverse than forward

I think u might have to re bind the receiver to remote...

It sounds like the wiring on the shifter is crossed. I would contact the service center at 1.801.655.0800 or look on the website
http://www.mypegperegoparts.com/switches.html
hope this helps