Question about Hotpoint Aquarius WD640 Front Load Washer/Dryer

1 Answer

Fabric softner still in drawer at end of cycle

Posted by on

  • Spindle73 Mar 19, 2009

    fabric softner still in drawer at end of cycle. Have checked for blockages but nothing there. Machine is approx 18 months old.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Try the inlet valve solenoid to see if any are open circuit
also the softner drain hole as it clogs

Posted on Mar 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fabric softner not dispensing, fabric softner remains in drawer and does not diepsne during wash cycle


Thanks for choosing FixYa and welcome. You need to make sure your hose is cleaned on the bottom of the dispenser. It is probably clogged.

Oct 01, 2011 | Washing Machines

1 Answer

Fabric softner does not empty into washer during rinse cycle


Hi not sure how these work as we dont have them in the UK. With UK machines the soap and fabric softner are put into a drawer that pulls out the front of the machine. When softner and soap arnt going into machine properly we take drawer out and wash it in warm water, you usually find a lot of gunk built up blocking it, perhaps you have a similar problem. Hope this helps

Jul 27, 2011 | Kenmore 43052 Front Load Washer

1 Answer

Despite cleaning out the drawer, the fabric softner is still there at the end of the wash. Have cleaned the drawer several times, but to no avail. Any suggestions?


Remove drawer/ look inside opening of washer ( at the top of opening inside) there is small little holes for the water to come through to fill the fabric softner spot and also bleach spot and detrgent spot. Holes may be pluged use a old tooth bush or some item to clean holes..Hope that helps thanks for voting.

Mar 18, 2011 | Washing Machines

2 Answers

The fabric conditioner drawer is always full of water at the end of the cycle, i have tried cleaning it and running the machine empty but nothing has worked.


fabric conditioner drawer is always full of water This video will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.

Feb 02, 2011 | Washing Machines

1 Answer

My washing machine fabric drawer is blocked have cleaned complete drawer but still fabric softner is in the drawer at the end of cycle .


Pull the little 'hat' off it's post in the fabric softener compartment. Clean off any softener residue and return.

Mar 17, 2010 | Hotpoint Washing Machines

1 Answer

Water in the fabric softner compartment after wash cycle


You need to poke all the holes clear in the top of the dispenser housing with a piece of wire or similar.
This should solve the problem.

Dec 15, 2009 | Washing Machines

1 Answer

My front load washer will not empty out the fabric softner. I have taken out the drawer & cleaned it. It will empty out the laundry soap, but not the fabric softner


I have the same problem with mine. I found that some fabric softners worked better than others. I found Downy the worst, when i switched the problem seems to stop once i cleaned out the drawer

Nov 30, 2009 | Frigidaire GLTF2940ES Front Load Washer

3 Answers

The fabric softner release has stopped working


Most likely the fabric soft dispenser is clogged . this happens when you wash alot in cold water the left over fabric softner get very pasty and can clog it up. You can try filling the dispenser with hot water and run a cycle with hot water this should unclog the dispenser .

Nov 26, 2009 | Hotpoint Aquarius WMA42 Front Load Washer

1 Answer

Washing power drawer, the fabric softner section


Pull the drawer out as far as it will come and then grasping it firmly, give it a good tug towards you, this will free the drawer to enable you to thoroughly clean every piece of it, particularly the conditioner parts of it.
Get a piece of wire with a bend on the end, and poke it in to all the holes in the top of the dispenser compartment, this will clera any blockages there.
Plz rate my solution, and feel free to leave any comment.
Thanks.

Jan 09, 2009 | Indesit W 123 Front Load Washer

2 Answers

Whirlpool duet fabric softner problem


It obviously is backed up or splashed in from the wash. And if it is just water why worry about it.

Aug 07, 2007 | Whirlpool Duet GHW9150P Front Load Washer

Not finding what you are looking for?
Hotpoint Aquarius WD640 Front Load Washer/Dryer Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

hungoverrr

Level 1 Expert

5 Answers

puggy666

Level 1 Expert

47 Answers

gbob59

Level 3 Expert

2963 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...