Question about Nextar MA933A MP3 Player

1 Answer

I dont know hopw to charge it

I plugged it into the usb port but its not charging

Posted by on

  • Anonymous May 23, 2009

    How do I charge nextar MA933A MP3 palyer?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Thats because it doesn't charge plugging it in lets you sync files from your comp it runs on batteries open the usb cover then slide the bottom off to replace the battery.

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will not recharge


Have you tried plugging this into a USB2.0 port ? sometimes, some of the usb ports dont not have enough power to charge some players.

Which is which is why, sometimes, (seen very often with external hard drivers) there are two usb plugs on the computer side which needs to be connected.


1) Try another USB port, or another computer (especially is this is a laptop, some of the ports are under powered, to save power)

2) if you have an AC Adaptor to charge this, try it with that

Feb 20, 2011 | SanDisk Sansa e200 MP3 Player

1 Answer

I dont how charge battery on my mp3 player


Some things to check for when your player does not act like its taking a charge. USB Cable Make sure that the USB cable is properly plugged in and use the original cable that came with your player. Computer in Hibernation mode Make sure the computer isn't entering hibernation or sleep mode while the device is connected. The computer must be ON in order to charge your player. USB Port 2.0 Make sure the player is connected to a USB 2.0 port (1.1 occasionally causes charging problems). USB Port location Try plugging into different USB ports (i.e. USB port in the back of the computer); occasionally the front USB ports have limited power to charge up the device. Battery Make sure the battery is fully charged. It takes approximately 3 hours to fully charge the battery. Latest firmware Depending on what player you have, make sure it's up to date with the latest firmware. AC charger (optional) AC chargers (sold separately) have a 500-1000 milliamp max output, which provides much better charging ability than a USB port.

Dec 25, 2010 | MP3 & Digital Media Players

1 Answer

How dont know how to charge my mp3 player


Some things to check for when your player does not act like its taking a charge. USB Cable Make sure that the USB cable is properly plugged in and use the original cable that came with your player. Computer in Hibernation mode Make sure the computer isn't entering hibernation or sleep mode while the device is connected. The computer must be ON in order to charge your player. USB Port 2.0 Make sure the player is connected to a USB 2.0 port (1.1 occasionally causes charging problems). USB Port location Try plugging into different USB ports (i.e. USB port in the back of the computer); occasionally the front USB ports have limited power to charge up the device. Battery Make sure the battery is fully charged. It takes approximately 3 hours to fully charge the battery. Latest firmware Depending on what player you have, make sure it's up to date with the latest firmware. AC charger (optional) AC chargers (sold separately) have a 500-1000 milliamp max output, which provides much better charging ability than a USB port.

Dec 25, 2010 | Philips GoGear Flash MP3 Player

1 Answer

I dont know how to charge my mp3 player and its dead


Plug one end of the supplied cable into the slot in the bottom of the Sansa. Plug the other end into a USB port of a computer. Make sure the computer is turned on, and it should start charging.

Mar 27, 2010 | SanDisk Sansa c250 (2 GB) MP3 Player...

1 Answer

When you plug the reader in to recharge is a red light supposed to come on until charged? How do you know when it is fully charged?


Yes, the red light should be turned ON after connecting the Reader to te Computer. That means the Reader is taking charge. After getting it fully charged, the red light will be turned ON. If those things will not happen to your reader, perform the below mentioned stepos::
1. Connect the Reader to a different USB port of the Computer. 2. Connect the Reader directly to the USB port of the Computer; dont use any USB hub or adaptor to connect the Readr to the Comp. 3. Disconnect the Reader and then press the RESET button. 4. Try connecting the Reader to a different Computer to check whether the USB port of the Computer is working properly. 5. If the issue still persists, service may be required. Follow the below link to initiate the repair: http://eservice.sony.com/

Feb 02, 2010 | Sony E-reader Portable E-book MP3 Player

1 Answer

I have ipod nano 1st gen and my ipod wont detect by itunes even my explorer using USB 2.0, i have firewire port wall charger when i try to plug it it charge but idont know if it will work to computer cause...


There might be a few issues here:

1. Your ipod software needs to be updated
2. Your usb cord is bad
3. Your usb port is not working properly

Either find someone that has a firewire port and update it via itunes, or use someone elses computer to update your ipod's software.

www.huskyipodrepair.com

http://repair-scratched-ipods.blogspot.com


Jan 26, 2010 | Apple iPod nano

2 Answers

How to charge My Mp3Player


Hi giannuandi,
Plug it into a USB port, and it should charge by itself. Use the USB cord Apple supplied for transferring data.

Dec 05, 2009 | Apple iPod shuffle MP3 Player

2 Answers

I dont relly know how to charge it plzzz help


It charges when you plug it into a USB 2.0 port on your computer when you plug it in to put the music on it with the supplied cord. Leave it plugged in for awhile it will charge it right up automatically. If you have an old computer that only has USB 1.0 it won't work, and you'll need to charge it on a different computer. Oh by the way the computer has to be on for the USB ports to have power.

May 10, 2009 | Memorex MMP8640 Digital Media Player

1 Answer

I dont know how to charge it


It actually has a battery in it. You need to take off the little end cover and then you can slide the battery cover off. It's on the back.

Feb 27, 2009 | Nextar MA933A MP3 Player

4 Answers

Craig cmp615d mp4 player


Turn off the player and let charge for about 4 hrs via USB port. This will charge the battery.

To upload songs to the player plug in to USB port and look for the removable drive through my computer or windows explorer. drag and drop MP3s into to removable drive window.

Jan 20, 2008 | Samsung Yepp YP-P2 Digital Media Player

Not finding what you are looking for?
Nextar MA933A MP3 Player Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nextar MP3 & Digital Media Players Experts

Joseph Hoffmann

Level 3 Expert

1687 Answers

Matt Piilo
Matt Piilo

Level 1 Expert

36 Answers

Are you a Nextar MP3 and Digital Media Player Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...