Front of microwave door scratched

Its not worth it to replace the door on that microwave, total cost of the door looks like 198.00 , maybe you could call GE parts and see if they have any in stock, WB56X10758 - However I highly doubt it is worth it. You are better off going to the website www.geappliances.com and finding a similar countertop microwave and just replace it with a new one. Perhaps if you call GE parts you could haggle them down on the cost of the door, however the labor of replacing it in that microwave isn't really worth it.

Frigidaire Microwave Not Heating Link to parts 20 out of 3 door switches are available =$228.Perhaps a new oven would be a better choice and cheaper.

There are usually 3 door interlock switches on most microwave ovens, which are held in place by plastic pieces which are screwed in place from the front of the microwave oven (although you may have to remove or tilt out the top of the control console to see them). Make sure these plastic support pieces are positioned against the front of the microwave oven, and make sure the screws are tight.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Good Morning Friend,

I understand the door will not latch on your Frigidaire microwave, model# FGMV174KFB. Typically, this would not be a do it yourself repair, as you are working with your microwave, and there are no step by step repair instructions. I suggest contacting your local authorized technician for further assistance. They have been trained on your appliance and should be able to fix the latch on your door with ease. Hope this is helpful.

-Best Regards-

WP

Check the manual for more details: http://kitchen.manualsonline.com/manuals/mfg/electrolux/b_81405.html?p=62

On a 1-10 scale- this is a 2.
place a cardboard box on the stove to support the microwave once it is free.
Remove power cord from the outlet in the cabinet over the microwave.
In the cabinet over the microwave, locate the 2 mounting screws.
Loosen each one about 6 turns- the microwave should drop down in the front by about 1/2 inch.
Once loose, you can remove both screws completely and allow the front of the oven to rest on the cardboard box.
While supporting the front of the microwave,have a helper remove the cardboard box.
Tricky part...while supporting the front - angled slightly down, lift hard under the rear of the microwave and pull toward you.
Have a helper feed the power cord through the upper cabinet bas as you bring the microwave toward you and slightly down.
Place the microwave on the counter- with a towel in place to prevent scratching the counter.
remove the rear-wall mounted support bracket.
Done

That would be a failing bottom door switch, or its mount.
My help file on door switches is here:
http://031d26d.namesecurehost.com/mwd/doorsw.txt
There's a video here showing how to remove a typical over the range control panel assembly in under 5 minutes.

Once the control panel has been removed, you can access the door switches for testing and possible replacement.
There should be a technical manual hidden behind the controller or grille, too.
If you need further part ordering help, contact Electrolux:
USA
800•944•9044
Electrolux Home Products
North America
P.O. Box 212378
Augusta, GA 30917

Canada
866•213•9397 (English)
866•294•9911 (French)
Electrolux Home Products
North America
6150 McLaughlin Road
Mississauga, Ontario, Canada
L5R 4C2

Try a Pop-Riveter, drill small hole insert rivet and squeeze handle.

I fixed the problem by buying a new microwave.  $200.00 for a repacement door is ludicrouis

Sounds to me like the door needs to be replaced.