Question about iRobot Roomba 530 Robotic Vacuum

1 Answer

Good Morning, My Roomba makes a banging sound and the brushes don't turn. It stops after about two minutes. Thank you & regards, Judith Halls

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 61 Answers

Hi Judith,

after removing and cleaning your Roomba's brushes & bearings (see the manual for instructions), try running the unit without the dust bin. You can watch the main brush while the Roomba runs. If it's not turning, it's time to call support.

Fembot

Posted on May 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Roomba 530 is clicking when running then stops


The battery is not charging and has died a noble death. Buy a new battery.

Nov 28, 2013 | iRobot Roomba 530 Robotic Vacuum

1 Answer

Irobot stops after a few minutes and says plaes


soooo, what is not understood here ?
turn it over, open brushes cage, take each brush out and clean it.
In addition, also clean the sides from any dirt/hair that may stuck in its pivots.
good luck
Avi

Apr 07, 2010 | iRobot Roomba 560 Robotic Vacuum

1 Answer

Front wheel problem


I would send it to protechrobotics. they will test all your components and let you know what needs to be done. if the repair is more than it's worth--they will help you out too.

http://www.protechrobotics.com/

Apr 07, 2009 | iRobot Roomba 4210 Bagless Robotic Vacuum

1 Answer

Roomba keeps saying clean brushes yet are clean!


Make sure you take off the little cap at the end (the one that spins -- just grab it and pull it straight off) and clean under it too. The rest of the brush may look perfectly clean but what happens is that hair gets stuck under spinning cap and, like a slowly growing washer, it pushes the whole brush toward the gear box. When it gets pushed over enough, the large yellow ring starts to rub against the side of the brush deck making it harder for the motor to turn the brush and you get that "remove and clean brushes" message.

Jan 30, 2009 | iRobot Roomba 530 Robotic Vacuum

35 Answers

Roomba keeps saying clean brushes yet are clean!


Remove the Yellow connectors on the end of the brushes and clean around the pin well. If there is too much there, the roomba thinks there is something stuck and goes into clear mode (as if there is a chord stuck).

Dec 26, 2008 | iRobot Roomba 560 Robotic Vacuum

1 Answer

Please clean Roomba s brushes warning will not stop after brushes have been cleaned Unit shuts off after one minute of cleaning


Clean the yellow brush bearings. Then run the Roomba without the dustbin, so that you can watch the brush while the unit is cleaning. Is it turning? If not, call customer support. 877-855-8593. Have your Roomba with you; they will want information from it. Good luck.

Dec 13, 2008 | iRobot Roomba 570 Robotic Vacuum

6 Answers

Roomba turning off after 30 sec.


I was having the same problem. Roomba would run for 30 seconds and then stop. I tried everything -- then I took the small rubber brush out and removed the small nut at the end. It was packed with dust to the point that it could not turn easily. I cleaned it out and now it is working like a champ. I think the automatic shut down was just a sign that there was too much strain to turn the brushes.

Nov 27, 2007 | Roomba Robotic Floor Bagless Vacuum

Not finding what you are looking for?
iRobot Roomba 530 Robotic Vacuum Logo

Related Topics:

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top iRobot Vacuums Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Brad Brown

Level 3 Expert

13530 Answers

The Knight
The Knight

Level 3 Expert

68229 Answers

Are you an iRobot Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...