Question about Packard Bell Motherboards

1 Answer

Typeface too big for monitor

When on the internet the typeface on the page is too big so am unable to view the whole page and as a complete novice with computers don`t know how to reduce it please help

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 29 Answers

Open the preferences menu in your browser and set the desired font sizes. It is possible someone has set minimum font size to too large a value. This works in Firefox. I am not sure about IE, as I don't use that crappy program unless i am forced to.
It is usually best to set minimum font sizes and allow the site to set the font to any value greater than the set value. Make this value the size you can read comfortably. Warning, anything smaller than 8 points is hard to read,

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No vga signal

Is this the only problem? Is it turning on?
Make sure monitor is set to VGA. Reconnect VGA cable, and check for bent pins. Try another cable if possible. Check another monitor.

If it is not giving you any beep codes, and you did all of the above, you have bad video on the motherboard. Use an add on card.

Oct 06, 2012 | MSI 945GM2 H-F (816909015911) Motherboard

1 Answer


here.. you must have an acrobat reader installed in your system to view this.

To view the whole page, on the right side of the download icon click the number 2N5777

Please rate this answer. Thanks.

Aug 16, 2010 | Motherboards

1 Answer

Unable to get ethernet controller drivers

Go to the Toshiba web site support page. Haven't personally been there but I assume you should reply to a few questions about your equipment model, serial number, etc, before it leads you to the download page. Once found, download the driver, save to your disk for a possible future reoccurrance, and run the install.
Good luck!

Aug 16, 2009 | Abit IC7 Motherboard

1 Answer

Intel DG31PR Motherboard BIOS menu and logo

Like I told you a few minutes ago, before we are able to help you fix your computer, we need some information, so we know what is going on: (1) The Name of the Manufacturer; (2) The Model and Model Number; the Mother Board ID and most of all we need to have a written description of how this thing happened i.e. information before failure, during failure and after failure. Anyway, you have my previous comments. We are of the opinion that we can help you enough, if you provide us with the information we need. Again a big thank you for considering our service. I will expect your reply to this communication. CONSTANTIN

Jun 11, 2009 | Intel Motherboard

1 Answer

Typeface too large for page

i use firefox so its on tool bar,view zoom in or out i think its the same for explorer

Feb 27, 2009 | Motherboards

1 Answer

Typeface too big for page

if u have a scroller on mouse click it then scroll this does the size is not right click on main screen and change display size.


Feb 27, 2009 | Motherboards

2 Answers


normally if the monitor is not working after switchin on the computer its the memory card remove the memory card and insert it rightly or some time with graphics card if bult in reset ur bios

Dec 04, 2007 | ASUS Intel 845 Chipset P4B (P4B WOA)...

Not finding what you are looking for?
Motherboards Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Packard Bell Motherboards Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers


Level 3 Expert

5660 Answers

Sunday Ojelabi
Sunday Ojelabi

Level 2 Expert

301 Answers

Are you a Packard Bell Motherboard Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides