Question about Samsung HL-67A510 67" DLP HDTV

1 Answer

Samsung DLP won't turn on-rapid clicking sound, lamp light blinks

When you push the on button, tv makes a rapid clicking sound from back of set. Music plays for one or two seconds, lamp light is flashing- no other lights flashing. Clicking sound stops after a few seconds. After say 20 seconds it starts clicking again. Lamp light stays flashing. No picture at any time.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

It was bad bulb

Posted on Mar 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Samsung HL-P5067W/HL DLP tv. When I turn it on cold the lamp light blinks on and off. The fan makes a high pitch sound a relay clicks the TV goes back to standby and the lamp light starts blinking...


This sounds like a lazy lamp--that is getting hard to start. Try a new lamp first. If you are inclined to do so--get a bard bulb and install in the old lamp housing and save some money. Get a real PHILLIPS bulb--it will last a while--compared to cheap generics that are good for maybe 6 months !!

Feb 18, 2014 | Samsung HLP5067W Television

1 Answer

Blinking Green Light on Mitsubishi DLP 52525


the circut that detects the bulb has been also failing in these sets
and the conversion chip that controls the picture , and the transformers are not putting out the full power they are supposed to.
this set will need to be tested to determine the exact cause or causes

Oct 18, 2008 | Mitsubishi WD-52525 52" Rear Projection...

2 Answers

Power button blinks green about 1 minute then goes red


There is an additional problem,

if the bulb had been replaced by a technician, call them back and ask for additional support, since they did not fix the problem.

Oct 15, 2008 | Panasonic PT-50LC14 50" Rear Projection...

1 Answer

Samsung dlp acts as though the lamp is gone. Put


It may be the ballast or aother problem. First, unplug your TV for about 5 minutes, plug back in. LISTEN very carfully when you turn the TV on. (put ear on the left hand side of TV towards the back) if you hear a clicking sound. It may be your light engine. BUT most important what lights on front panel are blinking.

Hope this was helpful, Big Irish.

Nov 21, 2009 | Televison & Video

1 Answer

I own a Samsung HL-R5067W 50'' DLP. Set is about 3 years old. Recently I heard a loud pop while viewing, picture distorted, but never went blank. I turned set off. When turned on again a loud whining noise...


Check your color wheel. There is a DIY guide for replacing the color wheel. Mine did the same thing yours is and my color wheel was all busted up. Unfortunately after replacing the color wheel my set continues to do the same thing, but this could mean I need to replace the ballast as well.

Sep 20, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

Samsung DLP TV has lot picture. Makes a Humming sound


That sounds most like the color wheel,
to change that you need to have some skill in electronics, I would recommend to take it to a shop

Apr 25, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

Samsung no picture


There are several capacitors that are known, in Samsung TV's that go out.. ( I replaced mine until the board was burnt through.. bought a new board, they went out again.. BOUGHT A LG TV!!)
Samsung settlement warrants older TVs with faulty capacitors

Samsung LCD Plasma TV Capacitor Repair Kit Replacement Parts

replacing these is not hard at all.. if you can use a soldering iron, you can do it..it just takes time..

Repair Samsung LCD TV Relay Clicks Shuts Off Won Come On

WATCH THESE VIDEOS FIRST.

Samsung TV Won Turn On How to Repair Bulging Capacitor for Clicking Noise

My Repair of 46 Samsung LCD TV with Bad Capacitors

Jul 18, 2017 | Samsung - Projection TV replacement lamp...

2 Answers

Samsung 46" DLP


HLP, HCN HL-S The Start-up Problem or/and
3 LEDs in the front blinking.

Unplug the set, pull out the lamp module (not all the way - leave it on the track) and push it back in.

Power issues (Tv not turning on) were typically due to faulty ballast. While the TV reports a bad lamp it is the ballast itself causing the issue. Samsung is well aware and will replace both the ballast and the lamp (since the lamp can be prematurely aged but the bad ballast). After replacment most people stop having issues.

Nov 08, 2007 | Samsung HLN467W 46" Rear Projection HDTV

Not finding what you are looking for?
Samsung HL-67A510 67" DLP HDTV Logo

1,720 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75581 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1689 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...