Question about Chrysler Vehicle Security Systems

1 Answer

99 Chrysler 300M alarm running battery down

Left the key in the ignition accidentally the other night, in the morning the battery was completely dead. Jumped it but the lights and alarm seem to be running so much that the battery is not able to recharge itself. Is this a problem with the electrical system? Or is it the battery?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 95 Answers

Battery was just drawn down so much that when it regained power it set the alarm off which flashes the lights. I would put a charger on the battery for a few hours untill its charged and that should solve the problem

Posted on Feb 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starter won't stop


Sound like your starter solenoid may have got damaged. Jump the solenoid connection to the large starter connection to see if you may have a fault in the ignition.

Jan 04, 2014 | Chevrolet 1995-1997 Chevy 1500 Truck...

1 Answer

Disarming alarm with key


If you haven't already, turn the key to the unlock position twice and see if that disarms the alarm. Replace the remote's battery. I cannot get into any detail because I don't know what year your 350Z is.
Good luck.

Dec 22, 2013 | Nissan Vehicle Security Systems

1 Answer

Battery key fob


Turn the ignition key on , open the hood, disconnect the battery for two minutes, reconnect and try .

Dec 14, 2013 | Audiovox Prestige Remote Start

1 Answer

I left my key in the ignition over night i charged my battery checked the starter and it still want start


you can sometimes 'unremember' your key. sometimes if you have too many keys on your key chain the computer can see your key, you should try the key alone first, if this still doen't work, you can try and re program your key, there should be instructions way better than i can give here in the manual. other wise you might have to take it to a dealer.

Jun 25, 2010 | GMC 1995-1997 Yukon Ignition Starter...

1 Answer

Viper car battery went dead now alarm light on


you are in valet mode.
find valet switch under dash or driver kick panel.
turn key on
then push the valet switch for a few seconds.
light should go out and then function properly again.

Jan 16, 2010 | Vehicle Security Systems

1 Answer

1997 silverado 1500 wont turn over


if the lights are bright and the blinkers still blink as fast as ever then the problem isnt the battery.. It may be the starter. smack it a few times with a hammer and it may start. If you jump the two wires on the starter the starter should turn over. If it doesnt turn and you did get a spark then the starter is bad. If it does spin then you have a ignition switch issue or starter relay issue.

Dec 21, 2009 | Chevrolet 1995-1997 Chevy 1500 Truck...

1 Answer

Battery went dead,clifford alarm locked the engine


Assuming that all is well with the vehicle's electrical system (fuses, etc...), the following should work, as Viper/Clifford uses the "fail safe" method of starter disable, and it only works to lock out the starter when the alarm is functioning properly and in the armed state.

That system has a "starter kill" system. When the alarm is actived, the starter kill is engages, and won't let the starter get voltage from the ignition switch. First thing I'd try is connecting the car's battery while the ignition key is turned to the "on/run" position. Cycle the alarm to arm, then disarm, so that the LED is not blinking. It also may require using the manual override button/switch (with the key on) to reset the alarm. Should start after that.

If all else fails, reconnecting the starter wires back together (they are spliced and running through the alarm via a SPDT relay.

Oct 23, 2009 | Viper Vehicle Security Systems

2 Answers

Unable to open doors with key due to discharge battery


you should not have a problem with this as the key is located in the remote and the alerm will sound but as soon as you put the key in the ignition the vehicle cancell the alarm[sword key in the remote

Jul 21, 2009 | BMW Anti-theft Alarm System 3 Series E90...

1 Answer

I have a thatcham TE2-1331/0305 I want to fit in my car but need a wiring diagram STERLING EXCEL THATCHAM TE2-1331/0305 ALARM IMMOBILISER Neil .


My 2005 Dodge Caravan head lights and dome lights stays on a little longer then the norm. Also the chime indicator that lets you know that you left the lights on or you left the keys in the ignition comes on as soon the door is open.I have had one battery go dead on me . Can't afford to be replacing batteries when they go dead on me! Can you help?

Jun 11, 2009 | BMW Anti-theft Alarm System 3 Series E90...

Not finding what you are looking for?
Vehicle Security Systems Logo

Related Topics:

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Vehicle Security Systems Experts

Larry Spears
Larry Spears

Level 3 Expert

625 Answers

xxxxxx xxx

Level 3 Expert

4706 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Chrysler Vehicle Security System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...