Question about Panasonic CT-36SX31 36" TV

Open Question

Schematic or service manual for RCA MM61110 or MM52110

I have a RCA model MM61110, 61" rear projection TV that will not power up. I suspect the HV powersupply section. Does anyone have the schematic and assembly print or a service manual for this TV that you could email me? I have the service manual for a Mitsubishi VS-45603, 50603, 50604 and VS-60603 that I would be happy to trade you if you are looking for them. The chassis number for the RCA set is MMC102G. My email address is bmcquitt2@yahoo.com.

Thanks for your time and any help....Bryan

Posted by on

5 Suggested Answers

  • 1 Answer

SOURCE: CONVERGENCE ic CHIP

I replaced the Convergence IC Chip STK392-110 for my PT-53WX42 Panasonic HD Rear Projection TV but I found burnt resistor(resistor #)R7053,R7002 & R7005.Can someone tell me the part# ,description,resistor value and power rating.I don't have the schematic to look .Thanks

Posted on Sep 08, 2007

SOURCE: pt-47wx42f service manual

it was the conv. ic, flashing led three times. any lines on a board? somebody already tried to remove them and butchered the board.

 i did find a manual for it.
thanks,
CC

Posted on Oct 24, 2007

ladywinn
  • 5138 Answers

SOURCE: real projection tv model# pt-53wx42f

you need to replace (2) STK392-110s some are 120s 150s up grade to 180s.Also after you replace them you will have to do complete alinement of convergence in order to do this you must have service codes.

Posted on Jan 21, 2008

  • 2278 Answers

SOURCE: tv schematics or service manuals

Check this site: http://www.eserviceinfo.com/equipment_mfg/Hitachi_2.html
Yoy may be able to find some in service manual by chassis number.
Good Luck.

Posted on Jan 31, 2008

SOURCE: PT-47WX49E - Looking for a schematic

Can someone help me take the board out? I dont know how to take off the white clips tracers on the side??

Posted on Feb 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power supply sparks when tv is turned on


That can either be the Flyback or the HV splitter. The flyback is located on the lower left hand side when looking in the rear and has a large red cable coming out of its top. The HV splitter is located in the front in the center of the set. These are both very easy and inexspensive to replace. I can post a link where you can get replacements with instructions.If you would like.

May 08, 2009 | RCA D61W20 61" Rear Projection Television

1 Answer

RCA MM6110 The TV is on but I am not getting a picture.


Have you tried resetting the cable box by unplugging it for 5 sec. and plugging it back in? (power cable)

Aug 27, 2008 | RCA MM61110 61" Rear Projection Television

1 Answer

RCA MM61110 Problems


I took the back panel off and noticed that one of the cooling fans was not working..... apparently the computer tells the tv that it will not be able to cool. I cleaned things using air and basically followed the wires for the cooling fan and wiggled them... lol.. works fine now

Jun 09, 2008 | RCA MM61110 61" Rear Projection Television

3 Answers

RCA MM52110 FUSE REPLACEMENT


Check on the power supply box. Lower LH corner in back where the plug goes in. There is normally a small breaker switch on it.

Nov 30, 2007 | RCA MM52110 52" Rear Projection HDTV-Ready...

1 Answer

Clicking


thats the power supply trying to fire up but there is a fault.

Nov 15, 2007 | RCA MM61110 61" Rear Projection Television

1 Answer

RCA 61" Model P61960 stopped working


You have a flyback transformer and horz output transistor bad

Nov 04, 2007 | RCA P61960 61" Rear Projection Television

1 Answer

RCA MM61110 Television


I had the same problem sometimes when my Gold Plus would reset itself and include all the channels but only those Over-The-Air channels. The only way I could change the programming was to completely shut down the power. Not just turning the tv off but completely unplugging it from the wall outlet. When you turn your tv back on you'll be able to choose from Antenna/Cable option. As for Guide,if you don't want to use it, don't set it up, it won't effect anything else on the television.

Aug 08, 2007 | RCA MM61110 61" Rear Projection Television

1 Answer

RCA Projection TV MM52110 Won't Power Up


Being able to read a schematic and understanding how a TV works are two different things. These chassis that RCA used in these sets can be somewhat complex to troubleshoot. I would geuess that unless the power light comes on at all then you have a dead power supply in the TV.

Apr 14, 2007 | RCA MM52110 52" Rear Projection HDTV-Ready...

2 Answers

P61940 RCA TV does not turn on.


Get a schematic and trouble shoot the main power supply if you have solid state experience. If you dont , PLEASE call a trained TV tech to assist you in this repair.

Sep 04, 2006 | RCA P61940 61" Rear Projection Television

1 Answer

Rca 61 inch tv


that "pop" was the flyback transfor, a resistor, or a capacitor bloweing up. if your not a technician this is considered a circuit repair and ther are no serviceable parts inside this set for you to replace without the proper tools , service manuals, and schematic diagram. Sorry man your gonna need a serfvice pro to help ya with this repair. Good Luck

May 24, 2006 | RCA P61927 61" Rear Projection Television

Not finding what you are looking for?
Panasonic CT-36SX31 36" TV Logo

Related Topics:

269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Televison & Video Experts

 Grubhead
Grubhead

Level 3 Expert

4706 Answers

The Knight
The Knight

Level 3 Expert

71182 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Panasonic Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...