I am not getting whether i can run my system with RAM ddr1 ,may i will get problems in future ?,it was supporting when i fixed RAM(DDR1) to motherboard and running smoothly.it was not specified in intel official site plz solve my problem as soon as possible
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Couple of items to try. First disconnect everything except the power and the CPU. Does it give you a beep code?
If not your either have a bad power supply, motherboard, or cpu. (Only if everything else is disconnected.)
Second, If you did get the beep code then put the memory in and see if the system starts to boot. (Try without the screen connected first. If it acts like is going to start turn it off, plug in the mouse, keyboard, and monitor and try again.) ** I have seen where an add on video card would keep the computer from starting so try with the on board video first.**
Third, start adding one extra piece at a time starting with the hard drive.
*********** board is Asus old p4 Mother board.It supports maximum 1GB RAM of DDR 400(DDR1). According to your post your computer having only one 512 MB working RAM. If you want good purformance you can upgrade your computer by purchasing another 512MB DDR400 RAM and install it on another RAM slot.If your computer have only one working RAM slot,you can purchase 1GB DDR400 RAM & install it on older RAM place. I think it solves your problem.if you have any problem come back with more information. I will try to assist you more accurately.
Check for the slots given on your motherboard, whether all the slots are same; However a motherboard can support only one type of module either DDR1 or DDR2.
your motherboard has only DDR1 slots.
You cannot upgrade DDR1 to DDR2 cause the Memory Module or notches are different than eachother.
Gimme Acknowladgement by rating me.
Dont know if i understand your question right, but il give it a try¨
Here is what your mobo supports in memosticks:
The Desktop Board D845EPI has two DIMM sockets and supports the following memory features:
2.5 V (only) 184-pin DDR SDRAM DIMMs with gold-plated contacts
Unbuffered single-sided or double-sided DIMMs
Maximum total system memory: 2 GB; minimum total system memory: 64 MB
DDR333/266/200 MHz SDRAM DIMMs only
Serial Presence Detect (SPD)
Suspend to RAM
If you stay to those memosticks you wont have any problem at all, not now and not in the future.
if you can get past the POST properly and see the drive size, nothing is wrong with the drive hardware. I think XP is seeing a previous boot sector install so try first to fdisk, format and system boot the drive. This should remove any boot sector "shadows".