- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Unable to Print XX
The machine has a mechanical
A foreign objects such as a clip or
ripped paper is in the machine.
Open the scanner cover and remove any
foreign objects inside the machine. If the
error message continues, do one of the
?? (MFC-440CN only)
See Transferring your faxes or Fax
Journal report on page 139 before
disconnecting the machine so you will
not lose any important messages.
Then, disconnect the machine from the
power for several minutes and then
1) Remove Plastic wire covers from inside printers, and release plastic stay on lower edge, tilt cover to 90 Degrees 2) make a note of where each connector goes 3) release the Ribbon and 3 Multicore cables, removing grounding screw, then remove scanner module by sliding it off the hinges at 90 degrees. 4) Remove Three Front Panel Screws, carefully leaver front panel upwards releasing front side clips. 5) Remove front panel by disconnecting ribbon and wireing on both sides. 6) Remove 6 Screws (2 on back, three at front and one middle right 7) Carefully remove speaker cable (Red Connector) and lift up plastic casing, leaving printer uncovered. 8) Re-Seat Encoder Strip into guide. (The Transparent strip) 9) Re-assemble in reverse and Hey Presto.