Forgot where to put water and solution lost manual

You don't say which model you have but this often occurs on the F5000 series. The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on the front of the dirty water tank is missing. The duct may have been removed to install the hose, and was not put back in place. It is a square plastic piece, about the size of a slice of sandwich bread, which slides into the front of the tank. A far less common reason for no pick-up is that the seal that the tank sits on has fallen off the motor cover suction tube. You will see a round tube on the bottom of the dirty water tank. This sits on top of a large rubber seal on the motor cover when the tank is in place. Be sure the seal has not fallen down into the hood.

heres a breakdown of that machine , and a chat line if you don't see what you need http://www.vacuumcleanershop.com/bissell_littlegreen_1720.htm

You don't say which model this is, but it sounds like the F5800 or F5900 series. The most common reason for lack of pick up is that the lid is not fully seated on the dirty water tank. Be sure to hook the two tabs on the front of the lid, and then snap the rear latch into place. Another reason is that the duct on the front of the dirty water tank is missing. The duct may have been removed to install the hose, and was not put back in place. It is a square plastic piece, about the size of a slice of sandwich bread, which slides into the front of the tank. A far less common reason for no pick-up is that the seal that the tank sits on has fallen off the motor cover suction tube. You will see a round tube on the bottom of the dirty water tank. This sits on top of a large rubber seal on the motor cover when the tank is in place. Be sure the seal has not fallen down into the hood.

Hi,

Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101

Please open the top white lid and unscrew the top black knob with instruction on the back of white lid.

Hi!  You can download the manual from www.bissell.com Click on the Customer Service tab, then in the next window click on the User Guides link on the left hand side of the screen.  You can then enter your model number and all will be revealed. Good luck!  If this is helpful please remember to rate my response.

user manuals are available at the bissell web site. on the customer care page.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_b96ba3f038cf317c

1. Release the handle and lay the machine
handle back to access the tank.
2. Remove the tank from the base of the
machine by lifting the tank carry handle.
3. Carry like a bucket to the sink. Rotate the handle forward
to unlatch the lid. Lift off and set the lid aside.
4. Fill up the bladder with clean hot tap water.
*Do not boil or microwave water as it can
destroy the bladder.
5. Replace the top of the tank by matching the
lid and tank edges. Handle must be in the
forward position in order to replace lid. Rotate
Note: Remember to secure the lid and test to make
sure it is secure before picking up the Tank.
6. Place tank into machine base, seating firmly in place.
Rotate tank handle back into latched position. Bring
machine handle back into upright position.

You can download the manual from the Bissell website www.bissell.com

hi,
Just recently purchased proheat 2x rug cleaner ,miss placed my manual and can't get the water sucked up . Please Help




Thanks

I have the manual scanned. Send me your email address and I will send it to you. I can't post it in this forum.

wilhouse

[email protected]