Aria diffuser does not emit any mist

Did you use distilled water ?

Ours called for distilled water to work correctly, we used tap water and it worked for the first few times. then started making noise and then stopped.

Started using RO water, (like distilled) and started working again.

That unit takes a 24 volt power supply. That is probably higher than what you have connected to it. http://www.youngliving.com/oil-diffusers/Home-Diffuser-US

This is not a motherboard problem.

I am having the same problem. I have no misting at all, only music and colors. I am going to try moving the glass spout so it's opposite the plastic spout--i read that somewhere. I'm also going to start over again with filtered water. I had gotten into the habit of just reflilling and adding more oils. hope this works and helps you too!!

One solution to try is putting the phone in a Ziploc bag along with some silica gel which absorbs moisture. It can be found for cheap online through many retailers http://www.silicagelpackets.com/silica-gel-packets is one of many options.

Other than that you can try leaving out in the sun or under a lamp and hope it dries out but without taking off the screen you don't have a whole lot of options unfortunately.

sounds like motor overheated and distorted pump replace whole unit

Most light domes twist on or off or have thumb screws to loosen and lower the dome.It sounds like you removed the light kit assembly instead of the dome.Try to put back by twisting in place the light kit assembly and look for screws,or hold back on trim and turn just glass dome do not use too much force .I checked web site but can't find your model.It is unusual to not be able to just remove glass dome.Look closely at how the glass dome is positioned. If no screws are visible either the glass part unscrews or the ring unscrews allowing glass dome to be removed.Good Luck.I have installed many ceiling fans the problem is if you didn't install it your at a disadvantage.GOOD LUCK.

Under the rear cover or under a small cap on the end opposite the shaft will be the shaft end and it should have a slot or key hole. Use a screwdriver or allen wrench to secure the shaft and then turn off the impeller.

John

First you will need to remove the inner door panel to gain access to the window motor and regulator. The are only serviced as a unit. You will need some masking tape or duct tap for the next step, on the bottom edge od the window glass you will fine that it is attached to the regulator. There are two clips you will need to remove ( they pull out fairly easy) Before removing them place strips of tape over the top ov the door frame down both side of the glass to hold it in place. Next disconnect the wiring from the window motor it will be mounted in the center of the door frame.You will find 4 bolts 1 in each end of the regulator. You may think your trying to get a square peg into a round hole wiggling the regulator out but it will come. Installing is the opposite of removal, just be sure to plug in your motor and take the tape off the glass before trying the operation and alignment before putting the door panel back on. Hope this helps

hi there,

i would recommend a technician to help you with this. this part that fell out is from the motor head off the icemaker. have the technician put it back together and make sure that there is nothing else loose.