Question about Brother Multi-Function Center MFC-240C All-In-One InkJet Printer
Hi Ok try this it may work.
Hapens a lot
Type in *2864
Type in 10
Code WSW00 shows
Type in 51
Code WSW51 0000001 will show
Try different values, eg change to 000000 or 0000010
BUT remember original code to get back to
To exit type 99
Also can try.
· Machine off
· Switch on the machine while holding down the “menu”button until all the leds are flashing on/off. Now you are in “maintenance” mode.
· Press 80
· Press the “mono start” button several times until you see “purge: xxxx”
· Press “2783” in order to reset the purge counter. You will see: “purge:0000”
· Press the "stop" button.
· Press “99” to exit the maintenance mode.
Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one
All The Best: Pineworks
Posted on Mar 02, 2010
a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
clean unable 46,see troubleshooting and routine maintenance chapter in user guide.Plase help me to splve this problem.
Posted on Aug 12, 2009
Usually this is caused by a foreign object or debris under the printhead path, or under where the printhead "parks."
Unplug the machine. Open the cover. Check the printhead path for little bits of paper, push pins, paperclips, staples etc. Note the location of the printhead.
If the printhead is at the far left, gently slide it towards the center (do not force it). Look carefully under where the printhead was stopped for debris. Use a flashlight if necessary.
Close the cover. Plug in the unit. Try again.
Posted on Jan 21, 2010
Posted on Jun 13, 2010
Could have a corrupt driver.
Disconnect the printer or at least be sure it is turned off. I'd do both and when the CD software program asks you to connect the printer to the USB port, do so and it should again work properly.
Hope this helps. Bud
Posted on Jan 29, 2009
Tips for a great answer:
Jun 25, 2014 | Brother Multi-Function Center MFC-240C...
Apr 07, 2013 | Brother Multi-Function Center MFC-665CW...
Jul 04, 2011 | Brother MFC 240C All-In-One InkJet Printer
Jan 09, 2009 | Brother Multi-Function Center MFC-240C...
Dec 31, 2008 | Brother Multi-Function Center MFC-240C...
Nov 29, 2008 | Brother MFC 240C All-In-One InkJet Printer
Nov 21, 2008 | Brother MFC 240C All-In-One InkJet Printer
6,587 people viewed this question
Usually answered in minutes!