Question about Bosch Axxis+ WFR 2460 Front Load Washer
Initially noticed a problem when clothing was removed and it was completely wet. Tested the spin cycle and the drum does not move. Attempted to begin load from start. Water appears to dispense but drum does not move. We needed to manually move the switch to drain. Water drained then cycle ended a couple minutes later.
Thanks for any help you can provide.
Hi sounds like the motor brushs are worn down,some bosch models you can change them without removing the motor ,but others its best to remove it,they just twist out,and to refit use a small blade flat blade screwdriver to tuck tab in,thanks
Posted on Aug 04, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You could try a tooth-brush. And after you fill your quantity of softener, top it with water till the exit level of the compartment. You could also check whether water actually pours into the compartment during the final rinsing of the clothes; in this case you should check the inlet pipe screens of your inlet pipe into the machine; which can be done without opening up the machine.
Posted on Dec 01, 2007
SOURCE: bosch wfr 2460 gb
Check your exit hose spigot, it may be clogged. This is if your filter is all clean. There should be air for passage in the standpipe behind. Your hose should not fit airtight into the standpipe and neither too deep into it. Snaking out your standpipe would be good too.
Rate me pl.....if helped.
Posted on Dec 29, 2007
possibly the motor brushes.
take back panel off and motor is held in by bolts which undo - also disconnect electrical plug and socket.
check condition of brushes
Posted on Oct 16, 2008
SOURCE: WFR 2460 Front loader
take the soap dispenser drawer out and clean the inside where the drawer fits into. Then give the drawer a good clean including underneath it, it could be caused by soap build up.
Posted on Oct 27, 2008
You need to check and clean pump filter, normally located behind a removeable plastic cover at bottom front of washer right hand side.
If no filter found there remove rear panel of washer, and clean pump from rear of washer.
Please rate my solution.
Posted on Nov 11, 2009
Testimonial: "Thank you so much. There were some wood splinters and a nail stuck in there! No wonder it wasn't working!"
Tips for a great answer:
Sep 09, 2014 | Bosch Axxis+ WFR 2460 Front Load Washer
Mar 07, 2014 | Bosch Axxis+ WFR 2460 Front Load Washer
Nov 25, 2009 | Bosch Axxis+ WFR 2460 Front Load Washer
Nov 11, 2009 | Bosch Logixx WFT 2806 Front Load...
Oct 30, 2009 | Bosch Axxis+ WFR 2460 Front Load Washer
Oct 16, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer
Mar 12, 2008 | Bosch Axxis+ WFR 2460 Front Load Washer
Nov 30, 2007 | Bosch Axxis+ WFR 2460 Front Load Washer
169 people viewed this question
Usually answered in minutes!