Question about Sony KP-51HW40 51" Rear Projection Television

1 Answer

How do I get to the blubs to dust them?

Can I take the front off?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Just remove the back panel and the bulbs are very accessable

Posted on Feb 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace parking lights on 2009 Audi A3


gotta remove headlight. replace the blub next to the hid tiny blub common problem

Jul 14, 2014 | 2009 Audi A3

1 Answer

Left turn signal does not work blub is good all thr rest work.


Follow the wires sounds like one of the wires may have come adrift.

Even though the bulb looks ok double check it by replacing it with a new one - they are only like $2.50.

May 17, 2014 | 2005 Honda Silverwing 600 ABS

2 Answers

Spots on screen with epson moviemate25


This sounds like a common 'Dust Blob' issue. Dust can accumulate on the LCDs or inside of the lens. You can sometimes take them apart, and use compressed air to clean the lens and LCDs.

Jul 10, 2012 | Epson MovieMate 25 Multimedia Projector

1 Answer

Dull picture how do I clean blub?


Its the small mirror in front behind the screen assembly needs cleaning. Dust gets the picture dim and dull looking.

Sep 22, 2010 | Mitsubishi WD-52525 52" Rear Projection...

1 Answer

Front passenger side turn signal blub only last about 3 months before going out.what could be the problem


Are you sure you replaced it with the correct bulb?also look at the connector and see if it looks burnt.If it does then replace it and when you replace the bulb add die electric grease to the contacts.This will keep the heat down.Good luck and I hope this helps.

May 10, 2010 | 2004 Cadillac SRX

1 Answer

Chrysler T&C (2005) - Can anyone describe how to access, remove, and replace the bulb in the crescent-shaped reading lights at the front of the overhead console. The owner's manual says nothing, and...


Start at the front towards the winshield with a very small flat headed screwdriver. Getting under the lip of the light cover in the front pop the 2 front clip down in the front. Do Not do this on the seat side or you brake the clip that turn the light on/off. After poping the front down, side out towards winshield. The blub removes by turning counterclockwise. Blub is a 578

Feb 07, 2010 | 2005 Chrysler Town & Country

1 Answer

How can I change the headlight on a 2001 optima


You may have to take out the battery, there are 2 round gray colored covers that screw out located in front of your battery that correspond to the location of the head lights, one is for the high beam and the other is low beam. once the covers are off, unplug the wire that is attached to the blub, there is a retainer spring that holds the blub in, take each side and push down and out and the blub should come right out. be careful not to touch the new blub with your fingers, only touch the base.

Jan 04, 2009 | 2001 Kia Optima

1 Answer

1990 Buick Lesabre Custom


You will need to include more information. !. Are you referring to the turn blub in the dash or the bluds mounted in the body of the car. If in the body of the car, you need to indicate whether it is front or rear.?

If the rear, open the trunk, and in the corner nearest the tail light you will see a cloth like material that can be pulled back, which will uncover the tail light assembly. From there you can remove the blub and holder by turning it to the left or right, pull it out and remove the blub.
Bill

Oct 25, 2008 | 1992 Buick LeSabre

Not finding what you are looking for?
Sony KP-51HW40 51" Rear Projection Television Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

kakima

Level 3 Expert

102366 Answers

The Knight
The Knight

Level 3 Expert

72670 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1667 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...