Question about Specialty Electrics

1 Answer

Need wiring diagram for hatco fr-5 rethermalizer

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 63 Answers

Hi my name is mark, that model is a burger king unit. you need to call them with the seral number to get diagram. check out hatcocorp.com

Posted on Mar 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Booster heater is leaking from the bottom'. I don't know the the make or the model.


Hi you may have taken care of this by now, but anytime they start leaking from the bottom, they have rusted out and you will need to have it replaced.
Shastalaker7

Jun 01, 2011 | Hatco C 24 Compact Electric Booster Water...

1 Answer

What is the resistance on a element on hatco c 15 booster heater when its good


I have some one getting back with me on particular numbers but it has been my experience they are either good or bad.If you show continuity then it is probably good.when checking continuity make sure you unhook both wires from element.then check from one side of element to the tank for continuity you should not get anything the meter will read ol.if you do get a reading then the element is bad replace it.

Mar 22, 2011 | Hatco C 24 Compact Electric Booster Water...

1 Answer

Leaking drain, I think?


hatco booster heater leak at pop off valve

Dec 27, 2009 | Hatco C 24 Compact Electric Booster Water...

1 Answer

Need to verify wiring on hatco 3sc9 sink heater/rethermalizer


hi my name is mark, leave your e-mail address and i will send a pdf file

Jan 29, 2009 | Specialty Electrics

1 Answer

Hobart LX 18 needs compatable booster heater


A hatco C9 or C12 would be plenty big enough.I would use the larger kw unit if incoming water is very low,but it needs to be 140 degrees coming in so it doesnt sometimes trip the hi limit.

Oct 11, 2008 | Hatco C 24 Compact Electric Booster Water...

1 Answer

Booster heater quits heating water after a few minutes of use and you must hit reset button to get it to work again. What would be causing this? For Hatco C36208 Booster Heater 3 phase


#1 I would check that you actually have 3 phases connected. #2 I would also check the ground. There could be a loose ground, or depending on the installation, the ground could be defeated by rubber washers in flex lines. Fix this by running a wire from the casing of the water heater to the pipe, bypassing the flex lines.
#3 Replace the thermastat. The thermastat has the reset button on it.

#'s 1 & 2 are very minimal in cost. #3 is still affordable.

Please rate this solution

Jul 23, 2008 | Hatco C 24 Compact Electric Booster Water...

1 Answer

Low hot water pressure but the cold water pressure is good.


If the build up is really bad you will have to take the whole unit apart. Remove all the elements and break up what you can with a wire coat hanger or something similar. Use a product like Lime Away. Check the elements carefully as they can be damaged by build up. You probably have one or more burned out from this. Check continuity and replace if needed. Make sure the wattage is the same as the old one. If it is a different shape make sure no element touches another. This should solve your problem

Jul 04, 2008 | Hatco C 24 Compact Electric Booster Water...

1 Answer

Water heater


There are 3 or 4 elements in there. One or more are bad. Just disconnect the wires and check for continuity. Check the thermostats too. The most common problem is sediment build up. If it is really bad you have to take the elements out and flush out the tank. Use Lime Away or similar product. Sometimes there can be so much build up there isn't room for the water and it will burn out the elements. This only has a 5 gallon tank so it doesn't takd much.

Jun 15, 2008 | Hatco C 24 Compact Electric Booster Water...

1 Answer

I purchased a whirlpool water heater(model #E2F0LD035V ) 1/30/08. Professionals installed it in March.The building inspector will not sign off on permit because it does not keep hot enough temp. (after...


They should stand behind their product. You may have to take them to small claims court as they will probably not pay for any install charges. They will probably offer to exchange the tank.

Apr 15, 2008 | Hatco C 24 Compact Electric Booster Water...

Not finding what you are looking for?
Specialty Electrics Logo

Related Topics:

223 people viewed this question

Ask a Question

Usually answered in minutes!

Top Specialty Electrics Experts

John
John

Level 2 Expert

473 Answers

Brad Brown

Level 3 Expert

13569 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Are you a Specialty Electric Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...