Question about Akai CTS2550 25" TV

1 Answer

When it get switched on no vedio is coming and a sound is coming from inside the TV

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Sound wil come from tv only chellam, if big sound coming maybe something livin inside tv, like small animal..

Posted on Oct 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Sunsui SV29276 TV is not switching on, but there is a hizzing noise coming from the inside of the TV


This is most likely power supply fault. Which unless you are an repair tech should be done by one.

Jan 14, 2014 | Standard (CRT) Televisions

1 Answer

No sound


Hello

First you check the speaker of your Daewoo Tv. To check the whether the speaker is good or damaged, place your year very close to the speaker side of your TV, and switch the TV by its front panel power switch, not by the remote control. If you can hear a "Thumb" sound from the speaker, as the TV is switched on, the speaker is good and you have to to further. If not speaker has got damaged and have to be replaced.
If your TV is provided with an earphone or headphone socket at its fron panel, insert a earphone or headphone pin into it and listen whether there is sound coming from it or not. If ther comes the sound, it doesnot comes to the speaker, means that the headphone or earphone socket is faulty. Replacing it will solve the problem.
If there is AV OUT from your TV, connect it to an amplifier or so to get the sound. If there is sound and no output from speaker, means the Audio Output IC inside your TV is faulty.
Just locate the audio output Ic, and replace it with same type and number. Audio Output IC can be easly located ans speaker wire goes to that section, and follow the speaker wire. locate it. If you need any more assistance, feel free to contact me through Fixya. OK.

Dec 07, 2010 | Daewoo DTQ-20U9SC TV

1 Answer

I plug my tv up and it won't come on. But when I unplug it it makes a sound like its being cut off.


This is a special symptom usually occurs with philips TVs. There is some sort of short inside your TV. It may be due to some circuit componets failure. Philips power supply systems are so designed that if any kind of short occurs inside the circuit board, the TV won't switch on. It is a protection. At the time you plug in the tv to AC the SMPS inside the TV works, detects a short and shuts down. When you switch off the set, the stored power inside the filter capacitor will be discharged through the power circuits, and a "WIZ" sound will hear. We can't predict the exact point of short in this case. It must be checked out correctly with patience. Anyway, without rectifying the short, your TV won't switch on. Please contact a service personal. Do not put it to on and off again. It may make the things more worse.

Oct 15, 2010 | Philips Standard (CRT) Televisions

1 Answer

Tv will go on but no picture or sound. not even menu comes up


i can not get the tv over to vidio mode so that i can run direct tv to it how do you change from tv to vedio from an out side source?

Jun 27, 2010 | Sylvania SRT2232S 32" TV

1 Answer

I have an LG TV (Normal one - not plasma). Picture sometimes comes and goes and then doesn't come at all. However sound is there. Any solutions


it is common fault in LG TV..there will be loose contact
in video driver board (attached to the tube)or vedio driver ic tda 6107 may be faulty..in rare cases the horizontal driver trans fomer will be gone..consult any service men

Mar 15, 2010 | Standard (CRT) Televisions

1 Answer

Vedio Card for Panasonic CTV TX-34G400W


Try Ebay.com or craigslist and look for one I am sure someone might have that part, good luck

Apr 22, 2009 | Standard (CRT) Televisions

1 Answer

TV pop and screen is black but I still have sound.


check your vedio transistor colector voltage is above 60 v

Apr 11, 2009 | RCA Standard (CRT) Televisions

1 Answer

Pacific 28" PTV 7017 TV will not power up properly


check resistor R639 it sounds as if it has burnt out (10k) don't ask me why ?

Nov 30, 2007 | Standard (CRT) Televisions

3 Answers

Tv on with sound but no picture


my jvc tv has sound but no picture. Sometimes when I turn it off for a few minutes it has picture then it goes black

Aug 07, 2006 | JVC AV-27230 27" TV

Not finding what you are looking for?
Akai CTS2550 25" TV Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Akai Standard (CRT) Televisions Experts

Josh Whitehead
Josh Whitehead

Level 3 Expert

1146 Answers

yadayada
yadayada

Level 3 Expert

60683 Answers

kakima

Level 3 Expert

96372 Answers

Are you an Akai Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...