Images or graphs print incompletly (missed parts found)

It is likely that the print-head temperature sensor is detecting an over heat. If that is the case, start thinking about a replacement machine as the printheads are expensive to replace.

Dear sir

I have encountered this problem on other printers. Try to clean the ribbon sensor found just above the head. It is a plastic digitizer strip used to align the head movement. Usually it has some grease on it just clean it with some cloth very gently.

Mark Borg

cannot detect alignment page- two possibilities-
1: hen the printer prints the alignment you can physically see the lines and colour shades being printed onto the sheet- this should then be scanned with the electronic eye built onto the carriage assembly- usually one automatic operation- if you can see a good clear image printed ( blocks/lines.boxes) and the printer cannot see the image it stands to reason the electronic eve ( spectrophotometer) is not reading the image correctly or at all, if however there are 'missing' areas of the calibration print then the problem lies with the printing side and I would recommend cleaning/ replacing the printheads as required

The printer needs enough RAM to store all the picture, before it starts to print any part of it. Can you add more RAM to your printer? Can you print a "less-complicated" picture?

Hi there try to reset the printer & then try. I hope its give u success. After that if u not success then uninstall the printer from PC restart the PC & printer & again install the printer. Then try.

Hi, please get new driver here: www.driversdown.com/
www.nodevice.com/driver/company/Canon/Printer.html
www.usa.canon.com/cusa/office/products/.../hs_1200ts

Jay jyhgsd

Common problem with this (and other) canon printers. I usually just lift the cover and lift the highlighted tank out and put it back in, sometimes I have to do that 2 or 3 times before it will let me print. If lifting that tank doesn't do it, try lifting all the tanks and putting them back. Eventually you will get a message that the tank you are refilling is empty (even if it's full). When that happens, press and hold the "stop/reset" button for 5 seconds (this is from Canon) then you will get a message that Canon will not be responsible for damage to the printer because you are using different ink than theirs (just ignore it). You can also try cleaning the contact points on both ink cartridge and on printer w/ cotton swab lightly dipped in alcohol.

It depends on the page you are trying to print. Some pages do not like printing everything on the page. What I have done is printed to PDF (with images) and then printed the PDF. You can find free PDF printers here:
http://www.google.com/search?hl=en&q=pdf+printer&aq=f&oq=&aqi=g%3Ap1g9

E220
The lamp intensity does not
exceed a specific value
within a specific time after
scanning operation starts
(following lamp activation).
• The lamp remains off for 10
sec when it should remain on.
E301 is
The output of the intensity
sensor drops below a specific
value while the lamp is on.
E100 is
The BD signal is not
generated during image
formation (2nd sheet pickup
and later).
• The BD signal cycle has
deviated.
• The BD signal is not
generated within 2 sec after
the laser has turned on (at
time of 1st sheet pick-up).

To have all three come up at differant times and intermittantly
I suspect the front door interlock switch is not being made properly or needs replacing

If you require more help please contact me by reposting
Thank You

For this print server it will not support any other function of the printer other than the printing part. If you are trying to use the scanner look for multifunction print server.