Question about Sanyo DS32224 TV

1 Answer

Power company turned power off for line repairs - tv no go since

I own an sanyo cp29kx2 tv. power button doesn't show power is on but i can hear a BLINK noise when turning tv on. red light at power button doesn't illuminate anymore - please help. i took back cover off tv - fuse inside looked o.k.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 39 Answers

Most likely fuse, main a/c filter, shorted bridge-diodes. this occurs often when surges of up to 220v line is run into house. we've had alot here in south texas after HURRICANE IKE. good-luck mch

Posted on Mar 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My flat screen sanyo tv has no remote how can i get another remote from the tv company?


Actually there are some universal remotes for the flat screen TV. I purchased a small philips remote at Kmart. I was hoping to find one for a flatscreen Polaroid I just repaired. And I was surprised to find this remote and it will function like the original. Try any of the super discount stores in the electronic section. Hope you find one. Thanks for asking! Show a few hands of support please.

Nov 14, 2010 | Sanyo DS31520 31" TV

1 Answer

Gray screen with horizontal lines accross it


sounds like you may have a bad ic it probley is a surface mount on the bottom of the board it could couse this problem would need to take to a shop to repair. The ic probley is numbered ic101 on board.

Mar 01, 2009 | Sanyo DS32224 TV

1 Answer

Turn tv on, shuts immediately off.


Same problem with my 28 inch 16:9 CRT Sanyo. I usually fix it by cutting the power to the outlet and then it works fine. Had it into the repair shop - and of course it never acts up there...

Jan 27, 2009 | RCA 27V520T 27" TV

4 Answers

Sanyo Model DP42848 42 inch


I just bought the Sanyo you inquire about and am afraid of this problem. Did you fix it? How do you like your tv? Wish I could help with your issue and appreciate your time, Pogo.

May 31, 2008 | Sanyo DS31520 31" TV

1 Answer

My Sanyo HT28745 28" HDTV clicks but doesn't turn on


I have had a similar problem with my tv, it has something to do with the power supply.Try unplugging your tv from the AC outlet. While unplugged from the power supply hold down the - volume control and then plug the tv back in while holding down the - volume control. It should bring up the service screen. If the screen turns on and is blank then it may need to be brought in for repairs.

If the screen does turn on, either blank or with the service menu, turn off the tv and unplug it from the power supply again. With it still unplugged hold down the power button on the tv and then replug in the tv. continue to hold down the power button until the tv displays a video signal on screen.

Feb 02, 2008 | Sanyo HT28745 28" TV

1 Answer

Sanyo DS24425 TV Has No Picture and Very Faint Audio


DONT BUY SANYO ELECTRONICS THEY ARE JUNK

Jan 09, 2008 | Sanyo DS24425 24" TV

1 Answer

Powers on but turns it self off after 15 seconds.


CHECK FLYBACK TRANSFORMER LEADS FOR BAD SOLDER JOINTS, HAVE REPAIRED SEVERAL WITH SAME PROBLEM.

Dec 02, 2007 | Samsung TXN3071WHF 30" TV

2 Answers

DS20930 TV


Sanyo makes a fine TV. You have a problem in the vertical circuit causing the line. You should not play the set in that condition because you can dammage the picture tube. Call a few local shops to get an idea of what they charge to fix a vertical problem on a 20" TV. If the cost of repair exceeds about 65% of replacement, toss it. In my opinion the newer sets are lacking in quality compared to older ones. In short , they break more often. If you choose to buy a new TV stay with a known Japanese brand.

Nov 29, 2007 | Sanyo DS20930 20" TV

1 Answer

Ds27510 tv sanyo


are you using the orginal remote that came with the tv? It should have a input button close to the power button

May 05, 2007 | Sanyo DS31590 31" TV

1 Answer

TV got sound but only shows a complete white screen and the message no signal connection


call a tech your tv needs to be repaired tv is having a problem in the video circuit ther is a cip that controls that circiut checks should also be made in the related circuit.video IF circuit.good luck

Mar 01, 2007 | Sanyo DS24205 24" TV

Not finding what you are looking for?
Sanyo DS32224 TV Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sanyo Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68223 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Sanyo Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...