Question about Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

1 Answer

Water not draining from the bottom of the dishwasher

15835 Kenmore built-in dishwasher. It's not grinding or leaking, just leaves some water in the bottom even after pressing 'cancel and drain.'

Posted by on

  • Kandy Newton
    Kandy Newton May 17, 2009

    yea..just leaves water in the bottom. It doesn't drain out.

  • Thomas Kautz May 11, 2010

    how much does a drain pump cost on a dishwasher?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 686 Answers

Vacuum it out with wet/dry vac and see if filter is dirty big peices of food will accumulate and stop it up if not check under sink where drain hose connects to main drain

Posted on Feb 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a five years old kitchenaid dishwasher that leaves water the in the bottom sometimes. I have replaced the drain pump and checked the drain hose for blockage but I still have the same problem of...


Propably you have leak from the main pump impeller seal.See the video below. It helped me to fix yesterday same problem.
http://www.youtube.com/watch?v=RLkMncM6JDE
If you open the bottom of the dishwasher you can see the leak.It leaves calcium at the base of the pump.

Sep 10, 2013 | Bosch 24 in. SHU43 Built-in Dishwasher

1 Answer

Kenmore dishwasher leaving a lot of water on door, bottom, wall and dishes! it STINKS!


The pump could be leaking. The drain could be plugged - hence the smell. Taking a look underneath could reveal what needs to be fixed. I don't have an answer for why dishes are still wet even after a hot wash and heated dry but perhaps it is related to the other problem

Oct 22, 2012 | Kenmore 24 in. 17482 / 17484 / 17489...

1 Answer

Kenmore ultra wash dishwasher 15835 it runs fine, but when is sets after its finished it get water in it and you have to press cancel to drain it again. Any idea?


Water inlet valve needs replacing. (about $50 for the part)
The valve is leaking and allowing water to enter the dishwasher even when it's off. You can turn off the supply line shut off between uses until you get the part.

Jun 14, 2010 | Kenmore Dishwashers

1 Answer

Kenmore Dishwasher leaking from bottom but not while draining....


Leak is associated with the water pump, either a hose or seal

Sep 29, 2009 | GE 24 in. GSD4020Z Built-in Dishwasher

1 Answer

Model 15754 Kenmore built in dishwasher leaking water into basement


take off the bottom panel ....... check for the leak .... could be the fill valve connection ..... motor pump assembly (most liklely) or a drain hose/pump issue....if the DW is noisy as well go shopping ...

Jul 22, 2009 | Kenmore 24 in. 15689 Built-in Dishwasher

1 Answer

Kenmore Ultrawash Quiet Guard 5 making buzzing/grinding noise


I have a very similar dishwasher, with a very similar problem. I fixed it by removing debris from the water evacuator pump located towards the front of the bottom of the machine (the last motor before the drain hose. In my case, grape stems had clogged it up. Once emptied, it purrs once again. NOTE: don't disassemble the motor, just flush it out, there is an o-ring gasket that is a bear to re-install.

Jun 22, 2009 | Kenmore 24 in. 15689 Built-in Dishwasher

1 Answer

Kenmore dishwasher makes grinding noise while draining


disassemble the top of the dishwasher pump, remove the bottom spray arm and remove the screws on the top of the pump housing this will get you started

May 03, 2008 | Kenmore 24 in. 15252 / 15254 / 15259...

1 Answer

Dshwasher has water on the bottom after cycle


Hi
Check the bottom of the machine and where water goes,there might be some scrap food,or other item that is not allowing the water to go in the time when the valve is open.This leaves some water and increases in other cycles,causing flooding on the floor.Also check for bend in the pipes at the back.
Hope this helps
jay

Nov 17, 2007 | Kenmore 16602 / 16604 / 16609 Built-in...

Not finding what you are looking for?
Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher Logo

Related Topics:

439 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Dishwashers Experts

Fred Sops

Level 2 Expert

271 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Raisin Brann

Level 1 Expert

28 Answers

Are you a Kenmore Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...