How to disarm Fujinon SRD-92B Zoom Rate Demand

Some fixya user told me a website reliable-store it is very good.. I used it to repair my shredder it had some spark issue which wasn't easily fixed. you can go there and try free

The case has to be opened for this, and a can of compressed air used. There is the risk that the binocs can be knocked out of collimation, so you'd best ask a repair tech for a quote.
.

fujinon srd-92b zoom demand not work.return button ok

Less Air Conditioning

1. On models equipped with airbag, disarm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. Disconnect battery ground cable.
3. Remove screws securing right ventilator control cable to instrument panel.
4. Remove screw securing right register duct to lower right edge of instrument panel.
5. Remove glove box and hinge bar from instrument panel.
6. Pull right register duct from installed position between air inlet duct and right register opening, Fig. 10.
7. Remove ventilator grille from bottom of ventilator assembly, then screws securing right ventilator assembly to blower housing.
8. Remove hub clamp spring from blower wheel hub, Fig. 11.
9. Pull blower wheel from blower shaft, then remove three blower motor flange attaching screws.
10. Pull blower motor from housing, disconnect electrical connector, then remove motor from vehicle.
11. Reverse procedure to install.
12. On models equipped with airbag, rearm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.

With Air Conditioning

1. On models equipped with airbag, disarm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. Disconnect battery ground cable.
3. Remove glove box door and instrument panel lower reinforcement from instrument panel.
4. Disconnect blower motor electrical connector, then remove blower motor and mounting plate from evaporator housing.
5. Rotate motor until mounting plate flats clear edge of glove box opening, then remove motor.
6. Remove hub clamp wheel spring from blower wheel hub and remove blower wheel from motor shaft.
7. Reverse procedure to install.
8. On models equipped with airbag, rearm airbag system as described underMAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.

It is most likely this one:
http://www.fixya.com/support/p223545-fuji_zoom_date_60_35mm_point_shoot/manual-1418#

I had this problem a couple of years ago. I bought a new battery compartment from Fujinon's US repair center: http://www.bakermarineusa.com. It was about $38. Unfortunately I now have the same problem with the new battery compartment. I'd like to find a source of the metal spring clips.

try to load the film again. if it does not show a number, then the film is not set properly.

change the size of the picture from camera option then its will zoom..
Plz dont forget to rate

http://www.fujifilm.com/products/digital_cameras/index.html


pleae take a moment to rate this solution