Question about Motherboards

1 Answer

Computer is continously giving a beep sound when switched on

The link light of the network adapter is not glowing while attach

Posted by on

  • 3 more comments 
  • Rodney Straumann Melo
    Rodney Straumann Melo May 11, 2010

    The numbers of beeps and the frecuency of them at startup are related to specific messages that are set by the manufacturer. The meaning of this messages are oftenly specified in the Motherboard manual and also on the web site of the vendor -under technical support or product specifiations pages. Then understanding the message and finding a solution depends on the information aquired. I humble suggest you provide the vendor name and product complete description as accurate as posible.

  • Thomas F. Schneider May 11, 2010
  • Thomas F. Schneider May 11, 2010
  • Peter Steiert
    Peter Steiert May 11, 2010

    Will the computer start and load the Operating System (Windows, Macintosh, Linux, etc...)? Will the computer display anything on the monitor? Are you sure it's only one beep and not a sequence of beeps?

  • Debs
    Debs May 11, 2010

    more information is needed

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Install you network drivers & configure your network via Windows networking wizard

Posted on Feb 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Product Name : Intel Motherboard Dg31gl Type : Mother Board Problem : 3 beeps continously then space then sham four then space again space again its repeating d same give me any solution


Replace the processor. The 3 beeps means its the processor at fault..
continuous beeps with space in between means its the rams.. No beeps at all means its the clock speed.

from what your saying it sounds like the processor.

Dec 28, 2012 | Motherboards

1 Answer

I have a gigabyte p4 pc, when i power it on the fan runs but it gives out a continuous beep. checked ram, processor on another motherboard, cleaned the motherboard, checked for loose cards and cables


The continous beep usually means a memory failure (RAM) or video memory if a plugin card is used.

Check to be sure the unit sees all of the memory, a weak power source( without AC adapter) could cause a partial failure of one memory card.

Another fault would be that the battery is very low on charge and won't accept any charge.

BAD Battery.

hope it helps

May 31, 2012 | Gigabyte GA-8LD533 Motherboard

1 Answer

I was using D845 GVSR mother board . The issue is that the system is not getting booted up . The power is coming to the board as green LEd behind the fan in the mother bid is lit up . If I press on the...


Test your PSU or replace it if your power supply units fan is not working your PSU is faulty

One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect/ boot up a computer hard drive

Test all leads that attach to your hard drive including electrical extensions,IDE,SATA

the leads from your "((motherboard to your hard drive))" make sure they have a secure connection and are not faulty or just replace them they could be faulty
make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty even the electrical extensions or just replace them they could be faulty a computer needs its connections to continue its cycle and have an end so any faulty leads will end up with a computer error hope this helps

Apr 26, 2011 | Intel D845GVSR Motherboard

2 Answers

Was workin ok but no signal imput now


One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect your hard drive

Test all leads that attach to your hard drive including electrical extensions,IDE,SATA

the leads from your ((motherboard to your hard drive)) make sure they have a secure connection and are not faulty or just replace them there probably old and faulty
make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty even the electic extensions or just replace them they are probably faulty a computer needs its connections to have an end so any faulty leads will end up with a computer error hope this helps

Mar 29, 2011 | Asrock K7VT2 Motherboard

2 Answers

Motherboard


TAKE YOUR DDR CARDS OUT ,, AND SWITCH THEM,, ,,IF THAT DOESNT WORK TRY WITH ONE AT A TIME,, GOOD LUCK

Oct 05, 2008 | AOpen MX46-533V (91.89U10.061) Motherboard

7 Answers

Intel motherboard 845gvs


intel 845 gvsr motherboard have two most problem

vrm circuit fail IC ADP3168 {between the cpu and core volt connector}
f7338 mosfet ic fail {between the memory slot and ide connector}

Feb 26, 2008 | Intel Motherboard

1 Answer

Continous Beeping sound


Hi neosw,

Could you provide a little more detail?

Was this a previously working set-up or is this a new build?

If this was a previously working set-up have you changed anything?

When you switch on the PC
  • do you see anything on the screen, does the monitor remain in standby?
  • are any of the fans running?
  • does the hard drive spin up?
  • does the beeping sound stop after a short while?
The reason I ask these questions is because a continues beeping usually means that the BIOS is not seeing the processor, or that the power to the processor is not correct. With some BIOS manufactures it can also mean the processor clock speed is not set
correctly.

Please don't take this the wrong way but...if you provide greater detail in your question, the easier it for us to diagnose your problem, otherwise we can only make educated guesses.

I hope this has been of some help.

Regards,

Spare head 2

Jan 06, 2008 | Soltek SL-K8AN2E (SL-K8AN2E-GR)...

1 Answer

No Video Output - HP 6635 Desktop minitower - CPU Intel CELEROM 533Mhz


if you have changed the monitor and the same no signal have you noticed a beep sound? or can you see the green and red light in front of cpu? if both of this doesn't light it's power supply and if there are led lights (green&red) lighting but there is a continous beep sound the problem is the on board video card. if a sound short beep, beep the problem is your memory card.

Nov 27, 2007 | HP (5064-6630) Motherboard

2 Answers

Problem with GA 8LD533


There are a few easy fixes for this, first,

Clear the CMOS (Unplug the power cord, remove the battery, and (if it's an option) move the jumper J1 (it has three pins, the jumper covers two, move it to cover the other one), unplug everything external from the motherboard apart from the PSU and power switch and speaker, replace battery, powercord, and jp1, power up - what happens?

Nov 19, 2007 | Gigabyte GA-8LD533(-P) microATX...

Not finding what you are looking for?
Motherboards Logo

Related Topics:

411 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motherboards Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

joecoolvette
joecoolvette

Level 3 Expert

5660 Answers

Mark Taylor
Mark Taylor

Level 3 Expert

728 Answers

Are you a Motherboard Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...