Question about Haier XQG50-11 Front Load Washer / Dryer

1 Answer

Front loading Haier HW-D1470TVE Door will not open. This inspite of the wash programme having ran and the digital dispkay reads "end". What can I do?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,902 Answers

Sounds like your door is locked. Unplug the unit for 30 minutes then plug it back it hopefully it will reset everything and you will be able to open the door. Then after you get the door open you will need to run some tests to see what is the problem. Check the door lock sensor and the door lock mechanism

Posted on Feb 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GLTF2940ES3 - Frigidaire Front load washing machine e59 error code


http://www.ehow.com/info_12127418_frigidaire-gltf2940fs1-not-spin-error-e59.html

May 02, 2014 | Frigidaire GLTF2940ES Front Load Washer

1 Answer

We have a haier washing machine hw d1470tve and it has just ended a cycle and has "END" flashing and then "UMB" what does UMB mean?


Hi from retired Englishman in SW France,
I am guessing at 'UNBLOCK'

I would gently suggest as a first step that you clean the drain motor/pump lint tray/filter. So many 'faults' are caused by blocked filters and many machines will not even go to rinse or spin or release the door lock if there is any water still left inside.
Following are my complete and hopefully 'coverall' pre-typed guidance notes for checking both the drain motor filter and the drain motor ;-0)
REMOVE POWER AND ENSURE YOU HAVE A WATER RECEPTACLE/RAGS TO SOAK UP THE WATER WHICH IS BOUND TO POUR OUT (alternatively use a wet vac as sensibly suggested by VinnyB1234!)
If you are unsure where the filter is, it is often behind the front lower (kick) panel (or in some machines at the rear in an awkward position!). These panels are either held on by (plasic) screws or will just pull off. Most filters are held in by a round cover/knob. Sometimes the filter will not come out with the cover and you will have to persuade it to come out to play.
It's surprising what people have found in theirs! It is always worthwhile checking it on a regular basis.
Now- whilst the filter is removed it is normally possible to see the drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF!
At this point it is also possible to test if the motor works. No clothes or water in the machine, select a spin cycle and put the power back on. You should be able to see the motor turning at some point, possibly straight away. Using something suitable like a glove see if it is easy to briefly slow the motor down. If it is easy then the motor is malfunctioning.

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C

Aug 27, 2011 | Haier Washing Machines

1 Answer

Washing machine is not working


Sounds like faulty door interlock switch / door should not be able to open during programme .....

Mar 30, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Washing machine finished its last wash and is no longer working ?


All HAIER Washing Machines come with a 3 year parts and labour warranty - Ring them and get them to come and repair..

Apr 10, 2009 | Haier Washing Machines

1 Answer

Hw 2 open the washiingb mashine door?


First you must check if there is power in your wall socket, then turn on the machine, try to gently open the door (the door has a catch). If it still does not open, press the 'end of cycle' button.

Click on your model number (below FIXYA) on this website, type in & search. You will get a shortlist; click on your model, below the page you will get Manual/Guides. Click on the blue, you have your manual on line. If available that is............

Feb 23, 2009 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

HAIER HW-C1460TVEME-U


Err1 : Door not properly shut
Err2 : Drainage error (clean filter check hose
Err3 : temperature sensor short circuit
Err4 : Heater error
Err5 : water fails to meet specified level within 8 mins check tap, water pressure
Err6 : motor error
Err7 : motor error
Err8 : water exceeds protective level check circuit
End : end of wash cycle
Unb : after the last rinsing cycle finishes spinning fails completelt due to unbalance of the laundry

only reason I know is i looked through the manual after getting it myself could be something to do with running a bath while washer on or something perhaps not enough water getting in if powder channel blocked

Sep 12, 2008 | LG TROMM WM2688H 4.0 cu.ft. Front Loading...

1 Answer

Door will not open


On my machine which is identical to this one I have to press and hold the stop button to end the programme and then turn off and unplug the machine to reset it. Following this run a spin only cyle(M) to get rid of the water.
Once the machine has drained and ended the M cycle try the door again. If this fails unplug the machine wait for a few seconds and then plug it in again and turn the program knob to any programme but do not start it running, just try the door it should open.
If all this fails it may be a problem with the contacts for the electrical stage of the door release or a faulty door lock.
Good luck, Al

Nov 08, 2007 | Hotpoint First Edition WMA22 Front Load...

1 Answer

Indesit WE14UK front loading washing machine door locked


try turning the timer knob/programme selector dial round to a black dot, switch appliance off then back on again. the red light should flash once, then pause, then twice then pause then three times. the appliance should now be reset and your door should open, if not there could be a fault on the main pcb control unit.
hope this helps
kj

Nov 07, 2007 | Washing Machines

1 Answer

Door cannot be opened


on my machine, the filter door on the bottom of the machine opens,inside there is a screw looking thing, i just give it a turn with a coin and the door pops open ,but this should tell you in your trouble shooting section of your manual, good luck

Nov 26, 2006 | AEG Lavamat 16810 Front Load Washer/Dryer

Not finding what you are looking for?
Haier XQG50-11 Front Load Washer / Dryer Logo

966 people viewed this question

Ask a Question

Usually answered in minutes!

Top Haier Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Owen Barnes

Level 3 Expert

835 Answers

Are you a Haier Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...