Question about Maytag LSE7806A Top Load Stacked Washer/Dryer

1 Answer

Maytag s1000 stacked washer will not start water fill and cycles.

The board works. the spin cycle is the only cycle that works. the dryer works fine.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 20 Answers

Could be wash spin relay stuck in spin must be 15 years old

Posted on Feb 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Maytag stacked washer dryer lse7806ace


Take the belt off the transmission pulley and see if you can turn it by hand. It will agitate on direction and spin when you turn it the other direction.
Put the timer to spin with the belt off and see if the motor will run. There may be a problem in the start switch on the motor letting it start in one direction but not in the reverse direction.
Special tools are required to remove the transmission and brake assembelies. You also want to make sure there is nothing sticking through the holes in the basket causing it to lock up such as a nail or screw that may have been left in a pocket.
Post back with what you find.
Thanks/Mike

Dec 05, 2007 | Maytag LSE7806A Top Load Stacked...

1 Answer

My washer will not fill up, only the spin cycle works. The dryer is fine


H20 supply is turned off, h20 valves are bad, or the timer is bad. if water is turned on, replace water valve, but first check to make sure power to water valves, if power is present, replace water valve, if not, replace timer.

Jun 25, 2009 | Maytag LSE7806A Top Load Stacked...

2 Answers

Maytag stacked washer/dryer fills with water, makes noise like it's working, but won't agitate, but at the end of it's cycle pumps out but won't spin either. Is this a belt problem? If so how hard is it to...


Definately sounds like the belt is off. Not too big of a problem for small hands mechanics. Usual problem lately with Maytag is the spindle pulley. For some reason they haven't been tightened properly and the pulley and belts are falling off. Pull it out from the wall remove the panel and see what you've got, really simple on the bottom end. Complicated stuff is up in the control panel. Make sure you get the pulleys lined up as close to level as you can or the belt will jump off on you during spin cycles. Good Luck!

May 10, 2009 | Maytag LSE7806A Top Load Stacked...

1 Answer

Maytag neptune mlg2000aww door will not lock or spin


Removing the top cover of the dryer, you will find, in the front right, the machine electronic control board with a burned resistor. This resistor burns up when the washer lock motor fails. The lock motor and control board will need replacing. Parts cost will be around $220.00.

Feb 05, 2009 | Maytag Neptune MLG2000A Front Load Stacked...

1 Answer

Water fills the washer during spin cycle


defective timer...a model # should be under the lid...or open dryer door and on front dryer panel right hand corner..onthejob

Jan 16, 2009 | Whirlpool LTE5243D Top Load Stacked...

1 Answer

Kenmore stack washer and dryer


gabehart....sounds like belt is slipping. Replace it. The water pump is on a separate smaller motor so is not affected by the agitator/spin motor.

Jun 04, 2008 | Kenmore 98702 Stacked Washer/Dryer

2 Answers

Washer stopped working??


change the pressure switch its the switch that you select the water level with

Mar 18, 2008 | Maytag LSE7806A Top Load Stacked...

1 Answer

Maytag LSE7804ADE Top Load Stacked Washer / Dryer


you'll need to by a sink kit at any hardware store and a sump pump , be advise at the place you buy . good luck .let me know take care

Jun 15, 2007 | Maytag LSE7806A Top Load Stacked...

Not finding what you are looking for?
Maytag LSE7806A Top Load Stacked Washer/Dryer Logo

Related Topics:

331 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Bill Long

Level 3 Expert

587 Answers

John Tripp
John Tripp

Level 3 Expert

4638 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...