Question about Hotpoint TDC32 Electric Dryer

1 Answer

Turned on for a few minutes now the start button wont turn

Ran for a few minutes then shut off and now the start button wont turn its stuck

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 547 Answers

Replace timer.

Posted on Feb 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Dryer is stuck on paused and won't spin. Turned off and re-started but the motor ran for a few seconds and then went to paused again.


Good Morning Jill,

So I see that you were drying bath mats and the dryer got stuck in a "Pause" mode and even if you cancel and restart it shows "Pause" on the display. I would suggest resetting the dryer. What you will need to do is either unplug it or you can shut the power off at the circuit breaker. When you do this you will need to leave it off for at least 2-3 minutes. Cut the power back on, start any cycle. If you are still having trouble not being able to start the dryer and "Pause" showing, I suggest you either contact the manufacturer or your local authorized technician. I hope this is helpful.

-Best Regards-
WP

Mar 25, 2014 | Electrolux Dryers

1 Answer

Frigidare AEQ600es2 does not heat. Reports error code E68, but all buttons seem to work.


You will nee The error code E68 is a stuck button error code. I recommend checking each button to make sure it loose in the plastic console. The button should rock side to side a little bit. If all the buttons are loose you can try to reset the unit control by unplugging the dryer for two minutes. If the error code comes back you will need to replace the unit control.

Apr 17, 2012 | Frigidaire AEQ6000ES Electric Dryer

1 Answer

Won't start


most of the time it is a weak motor going bad,to weak to turn the drum-mike

Feb 06, 2010 | Kenmore Dryers

1 Answer

Knemore 80 series dryer won't start every time


Go to www.repairclinic.com and enter your model number and it will show you all your parts, but I suggest you change your thermostats and basically have the dryer cleaned out of possible lint build up on the interior

Mar 20, 2009 | Kenmore Dryers

1 Answer

Whirlpool electric dryer will not start.


If you can hear a HUM sound when you press the start button, your motor is probably bad and needs to be replaced.

Dec 12, 2008 | Dryers

1 Answer

Dryer shuts off after a few minutes


THE KENMORE DRYER I HAVE... IF REN IN THE COTTON CYCLE IT WILL RUN FOR 50 MINUTES AND SHUT OFF. ITS BOLWING HOT AIR AND THE OTHER CYCLES SEEM TO WORK FINE WITH OUT SHUTING DOWN SO ID APPRECIATE A TIP ON WHAT THIS PROBLEM COULD BE

May 17, 2008 | Dryers

1 Answer

Dryer starts on it's own when timer is turned or door is shut


its the door switch more than likely are less likely the push start button stuck

Mar 16, 2008 | Dryers

Not finding what you are looking for?
Hotpoint TDC32 Electric Dryer Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Dryers Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Chris Hall
Chris Hall

Level 3 Expert

842 Answers

Are you a Hotpoint Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...