Change my phone to touch tone

There isn't a dedicated button to switch between tone and pulse dialing. Follow the instructions on page 14 of this manual.

There isn't a dedicated button to switch between tone and pulse dialing. See the instructions on page 14 of this manual.

Push the same button you pushed before, it should reverse it.

Hello,

Read the manual to reconfigure that option. (Look for Setup button on the phone) I can't guess what model you have. On older phones one could find a switch on the the phone to flip between Tone and Pulse.

Sorry I could not be of much help.

Check the base unit for a switch that says Tone/Pulse and switch it back to tone.

Hope this is of some help.
Ed

There is usually a switch to change it from dial pulse to touch tone.If there is no switch check your user manual to see if there is a screen option.

tk46

in GE:

TONE/PULSE DIALING
This adjustment allows you to select tone (touch-tone) or pulse (rotary) mode dialing. The phone is pre-set for
touch-tone use. To set to tone or pulse dialing:
1. Press and hold the program button for two seconds. You will hear a beep.
2. Press the *tone button to select Tone Dialing or press #pause to select Pulse Dialing.
3. Press the program button again. You will hear a confirmation tone.

Lisa, If the 900MHZ phone is Model 26928M programming for rotary dial usually goes like below, can't hurt to try on any model. TONE/PULSE DIALING This adjustment allows you to select tone (touch-tone) or pulse (rotary) mode dialing. The phone is pre-set for touch-tone use. To set to tone or pulse dialing: 1. Press and hold the program button for two seconds. You will hear a beep. 2. Press the *tone button to select Tone Dialing or press #pause to select Pulse Dialing. 3. Press the program button again. You will hear a confirmation tone.

Instr man is here:

http://www.home-electronics.net/ge/pc/IB/27957GE1_IB.pdf

You’ll need either a 6-button or a 24-button set SPIRIT CS administration.

First the control unit ADMIN switch must be ON, the administration overlay must be in place on station 10, and the set must be plugged into control unit jack 10 (call processing is interrupted only at station 10).

After moving the admin switch, and before dialing Ftr 7 -
From station 10 press intercom,
Press speaker,
Dial *0,
Dial 1,
Then Press Ftr 7.

Each line indicator light will show the current dialing type for that line. If the light is OFF, that line is set for touch tone dialing. If the light is ON, the line is set for dial pulse
dialing.

To change the dialing type for a line or lines, press the line button(s) and dial the
appropriate digit from the table below. You may press more than one line button to make the change on more than one line. If you enter a digit without first pressing a line button you will hear the error tone.

Be sure to turn the admin switch back off when you’re finished.