Epson Stylus C88 puts the job in the queu and doesn't print

change the printer settings to print in black and white

You should run a nozzle check to verify if the heads are printing all the inks correctly. If the pattern is incomplete you need to run head cleanings.

Found the drivers on the Epson Web Site. Just click on link below for manual and drivers and support.
If you find this information helpful, pls rate me.

http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?BV_UseBVCookie=yes&oid=58602&prodoid=58654751&infoType=Downloads&platform=Windows

Good Luck................

try replaceing the ink:)

It looks like storm_christ has lost interest in this problem, so we may call it "solved by poster".

If you have carried out 4 to 5 head cleans, waited about 8 hours and done another 3 or head cleans doing nozzle checks after each clean (as recommended by the manual) and there is still no improvement then you will need a third party head cleaning solution such as this one:
http://websites.uk-plc.net/UK_Inkjet_Cartridges_PLUS/products/Print_Head_Cleaner.htm
Other makes & brands are available just google "inkjet head cleaning solution" Hope this helps.

Go to this website:

http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?BV_UseBVCookie=yes&oid=58602&prodoid=58654751&infoType=Downloads&platform=Macintosh

When your there you should be able to use one of those drivers for your mac.

From the lack of interest by koolcorgipro in this problem, I think we may say it has been solved by the poster.

yes you have to go to control panel and remove the drivers and install the drivrs again ok

See my post about about underhead cleaning. If that makes no difference you will need the countermeasure for the split cap tube. The document about loss of ink on CX series machines is also applicable to C88