Question about JBL Speakers & Subwoofers

1 Answer

My JBL SCS200.6 subwoofer coughs

Hello,

for some itme now, the subwoofer always coughs, rarely hearing the normal sound. I went to the retailer but they could'nt fix it. It seems that there is a problem with the speaker itself and not the amplifier. It does this without being connected to anything else, so it is not the source.

please help, thanks

Posted by on

  • cristi_chiru Feb 18, 2009

    strange... because sometimes works.. especially if i turn de sub upside down :) the membrane is not punctured or ruptured. I really hope is not the coil...:( i will look tomorrow for a replacement

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

It sounds like the voice coil is blown. You could price just buying a replacement sub for it or pricing a whole new unit

Posted on Feb 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sound drivers samsung laptop


Sounds like a problem in the setup.

Oct 18, 2013 | Speakers & Subwoofers

1 Answer

Light stays red, will not switch to green. I hear no sound from the subwoofer


Red Light Constant On - Means the Amp Is Not Turning On - Signal Problem or Most Likely Burnt / Non Working Components - There Is A Guy On Ebay Who Repairs these amps.

Jun 19, 2011 | JBL Venue SUB10 Subwoofer

1 Answer

I HAVE a JBL 180 SUBWOOFER and the soundlevel control has some flat spots where there is no sound so I believe the potentiometer needs to be replaced, So I unscrewed all screws holding the electronics box...


Is that really necessary? In most installations that pot is a set-and-forget control. Find a sweet spot and live with it. I've always gone into a speaker by removing the driver.

Apr 14, 2011 | JBL Venue SUB10 Subwoofer

1 Answer

JBL E250 went dead after making loud sound. Doesn't power on at all now. Bought it at Best Buy in October of 2006. Does'nt it have a 5-year warranty?


It could be a bad or bad capacitors. On the power board. Capacitors look like soda cans small soda cans. Good ones will have a flat top. Bad ones will have a biging top and sometimes fuilid sedimant leaking from them..

Apr 03, 2011 | JBL Northridge E 250P Subwoofer

3 Answers

JBL PB10 subwoofer sounds distorted and lights on the front flash


More likely to be the Class D power amp module, but you should look through the service manual to make sure all the parts are installed correctly. My PB10 AMP module went out and you cannot get one anymore.
http://manuals.harman.com/JBL/HOM/Service%20Manual/PB10%20sm.pdf

Nov 10, 2009 | JBL PB10 Subwoofer

1 Answer

Pb12 makes thumping sound after warming up


Hello there..Thats normal only if your sub volume and the pre amp is turned up..Your amp is the cause of the speaker jump..Turn amp volume sub level down a few and check your wire from sub to amp..If all of that is good is a normal operation for pre amp warm up in sub if level is turn to max..Try unplugging amp freom sub then turn sub on stand alone(just sub outlet plugged in and no wires from base amp plugged in..If sub stops the its the amp making the problem..If it still is there then the pre amp is either dusty on inside or the outlet plug that it is plugged in doesnt have a good ground..Hope these help to solve your problem..Have a great day...

Apr 02, 2009 | JBL PB12 Subwoofer

2 Answers

E250P Not powering on... chirping noise


I had the same chirping issue with the sub. I found a document that talks about replacing the C5 capacitor for a 47mfd type instead of 470mfd. This solved the chirping issue however I still experience an intermittend issue with the power on indicator flickering off and on. Anyone hear of the fix for this?

May 12, 2008 | JBL Northridge E 250P Subwoofer

2 Answers

PB10 Loud Hum and Crackle- LED Lights mixed Red/Green


Hello, Jesse. I doubt I can help, but there is at least one SIMPLE thing you can try - with maybe a 10% chance it wil return your unit to normal: Unplug the unit for 30 seconds, then plug it back in to a DIFFERENT outlet. Oh, yes - there are NO fuses or other "reset" devices. I'm sorry I couldn't offer you more help.

Jul 25, 2007 | JBL PB10 Subwoofer

Not finding what you are looking for?
Speakers & Subwoofers Logo

Related Topics:

857 people viewed this question

Ask a Question

Usually answered in minutes!

Top JBL Speakers & Subwoofers Experts

Michael Edwards
Michael Edwards

Level 1 Expert

53 Answers

 Grubhead
Grubhead

Level 3 Expert

4593 Answers

shaqsatin

Level 1 Expert

17 Answers

Are you a JBL Speaker and Subwoofer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...