Question about Ovens

1 Answer

Instructions for lighting grill for Leisure Cooker GR6GV MKII

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 979 Answers

Have your flame next to the pilot light before turning on. Hold pilot knob in while lighting. Hold it in for about 30 seconds once it is lit. Then you can turn it to the on position and set the temp.

Posted on Feb 25, 2013

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: leisure rangemaster 55 gas cooker

It sounds exactly the same as I am experiencing on my oven of the same model. My theory is that the full flame gas is controlled by a thermostat, and that this has broken hence why the oven only stays on preheat. This will be a matter of a replacement part. Most likely the thermostat is a bi-metal strip that, because it has heated and cooled so many times in it's life it has simply finally given up. Try searching online for the correct part and get a corgi registered fitter or another suitably qualified fitter to come and replace it.

Posted on Apr 07, 2008

  • 1 Answer

SOURCE: I need a set of installation instructions

how do i uninstall a hotpoint doubl aven 27 inch wide 50 inches tall chris

Posted on Oct 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas hob will not light on my leisure gas hob


At the rear of the oven is a gas cut off valve. Try twiddling it

Nov 24, 2013 | Ovens

1 Answer

Both ovens in my gr6gv leisure dont get hot enough


http://leisurecooker.co.uk/Manuals/BrochuresManuals See if this can be of any help Kolbrun

Sep 18, 2013 | Ovens

1 Answer

Location of thermal fuse in leisure cookmaster range cooker


where is the thermal fuse located in a leisure cooker

Jul 22, 2010 | Ovens

1 Answer

Just bought a Leisure Gourmet Classic gas cooker. Connected the gas and plugged it in but none of the burners will light. The ignition is working but no gas is getting through. Any ideas folks? TIA, Andy


I had a similar problem when my new Leisure cooker was installed last December. The burners would light when I held the knobs in but when I let go the flame would go out. The engineer took off each of the burner knobs and stuck a small wad of aluminium foil between the inside of the knob and the contact on the front of the cooker - he said it's a design fault and the gap is just a bit too large for contact to be made reliably. This fixed the problem and I've had no trouble since.

Jun 22, 2010 | Ovens

1 Answer

I need a set of installation instructions for a Leisure 2100EL gas cooker


how do i uninstall a hotpoint doubl aven 27 inch wide 50 inches tall chris

Feb 03, 2010 | Ovens

1 Answer

I have a Beko 'Leisure alta AL6ND' oven. The thermocouple has gone in the oven (ignites but not staying lit, all other burners and grill fine). I can get the back off easily, but the thermocouple screws in...


remove rear panels (3; 1 white, 2 galvanised).
look under rear folded edge of hob. remove 2 screws in corners. dont lose 2 top hat rubber washers. from rear of cooker, lift hob slightly and push forward 1/2". lift hob off. dont over tighten new thermocouple union on back of valve (note how tight old one was)

Dec 01, 2009 | Ovens

6 Answers

Leisure rangemaster 55 gas cooker


It sounds exactly the same as I am experiencing on my oven of the same model. My theory is that the full flame gas is controlled by a thermostat, and that this has broken hence why the oven only stays on preheat. This will be a matter of a replacement part. Most likely the thermostat is a bi-metal strip that, because it has heated and cooled so many times in it's life it has simply finally given up. Try searching online for the correct part and get a corgi registered fitter or another suitably qualified fitter to come and replace it.

Nov 13, 2007 | Ovens

Not finding what you are looking for?
Ovens Logo

Related Topics:

437 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ovens Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Brad Brown

Level 3 Expert

18060 Answers

Are you an Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...