Hi i have no power going to my tv when its plugged into to power

Please make sure the tablet is charged for at least 4-6 hours. Also, make sure the correct button is being used, oftentimes we hear the back or home button has been used in error. If the issue persists, you can try performing a power reset. There should a power reset button near the charging port. It looks like a tiny hole. While plugged into the charger, use a paperclip to push the button inside this hole for 3-5 seconds. If it turns on, please allow it to charge for 4-6 hours before using it. If you leave it on the charger for longer than the allocated time, you will go back to having the same problem as before. If the power does not come on, please leave it plugged up for 4-6 hours then disconnect it from the power and turn it on.

If your tablet does not have the reset button: With the tablet plugged into the charger, hold the power button for 10 seconds then click the volume up once. If it turns on, please allow it to charge for 4-6 hours before using it. If you leave it on the charger for longer than the allocated time, you will go back to having the same problem as before. If the power does not come on, please leave it plugged up for 4-6 hours then disconnect it from the power and turn it on.
Support Troubleshooting Guide

Ur tv have a power supply board problems,it dead.That the board where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.Or the tv shop,will cost u like half of the price of the new tv to repair it.

Try unplugging the the TV from the power outlet for 30 seconds to a minute and plug back in again. Try to turn on again. Some TV's have to be in a "ready mode" to operate by remote - so besure it is in that mode - or use the power button on the TV.

Good luck!

Could be anythings wrong with it,must hire a tv Tech.to troubleshoot and repair.Because doesn't know the causes and the problems was in storage 5 years ago.Tries check all cales wires plugs in connections are tightly connected and no loose connections wires on those PCB boards,might help make the tv it work again.

First lets try the basics...
1 check the AC cord for flaws
2 try plugging the TV in another wall outlet (always use a surge-protector) then try powering the TV on again
3 plug tv into surge protector, plug into wall then find the house fuse box going too that outlet and turn it off & on once. Then try powering the TV on again.
4 it could also be the ac fuse inside the TV that blew from the TV's last usage.
If its been in the cold or in excessive thermal conditions for 6 months you could have moisture build up on the boards or warping...
hope this helps, contact me at the link below for further help...
http://tvtechwork.webs.com/

Hi, Please check the power line feeds to compressor. It may broken

Hi,

CLICK HERE to go to HP website to order one power module.


Regards
Riztech

Some foriegn tv's require yo to change the channel to get the picture to appear or push a secondary button to get the tv going

I remember Jvc put out a service document about changing 2 transistors in the power supply..they are surface mount on the solder side of the pcb. You might not find the parts anymore unless your very tech saavy. Sorry man..

This may be a liitle more informative to you....if you haven't already read it. This fixed my problem, I had 2 blown caps.

Hope this helps!
djrhemi345