Hi welcomejee i had live session with you but have lost all information you have given me please help

If your problem is "switch on then after 10secounds shuts down and protect appears on the display .and cannot do anything with it but turn it off"

Then the unit is on protect mode, that is a special diagnostic mode that starts when the unit detects an internal fault.

To start unplug the unit from power for ten minutes, and see if this reset the protect mode, I guess you have done this already.

The first thing to do is to start the unit with nothing connected, if the unit does not go to protection, then the problem was one of the cables or a connected device.

If that does not fix it , there is a master reset , by pluggin the unit into main while at the same time you hold the power button.

If still no luck then the unit is defective and must be taken apart and tested with a multimeter.

You start checking for burnt areas on circuits, cold solder joints and leaking capacitors at sight, then there is need to grab the multimeter and do the real testing job.
When you find the problem you do the soldering.

Naturally this requires a certain experience in fixing electronics, to complete the job usually a precision soldering is needed.


If your problem is "switch on then after 10secounds shuts down and protect appears on the display .and cannot do anything with it but turn it off"

Then the unit is on protect mode, that is a special diagnostic mode that starts when the unit detects an internal fault.

To start unplug the unit from power for ten minutes, and see if this reset the protect mode, I guess you have done this already.

The first thing to do is to start the unit with nothing connected, if the unit does not go to protection, then the problem was one of the cables or a connected device.

If that does not fix it , there is a master reset , by pluggin the unit into main while at the same time you hold the power button.

If still no luck then the unit is defective and must be taken apart and tested with a multimeter.

You start checking for burnt areas on circuits, cold solder joints and leaking capacitors at sight, then there is need to grab the multimeter and do the real testing job.
When you find the problem you do the soldering.

Naturally this requires a certain experience in fixing electronics, to complete the job usually a precision soldering is needed.

If you want to communicate with welcomejee , click here, on your profile link:


kdenn
then click on the chat and scroll down to the bottom of the page, there you will find add comment.



If you want to communicate with welcomejee , click here, on your profile link:

kdenn
then click on the chat and scroll down to the bottom of the page, there you will find add comment.