Noise in the audio output for KORG PA-50 (Keyboard / Muscial)
I have a keyboard KORG PA50, which is having a touble with its audio outputs. When i play the instrument without connecting to an amp/speaker it sounds perfect (i mean when heard from its inbuilt speakers ).But when i connect the instrument to an amp/mixer all i can hear is noise. I tried to connect the instrument through the headphone output but still it sounds bad. Could you please tell me whats wrong with it, if as i think it was a short in the pickup, how expensive will it be to repair/replace that part of the instrument?. I'm mailing from India, and it would be so helpful for me if i can get your advice on this.
Re: Noise in the audio output for KORG PA-50 (Keyboard /...
Hello. My KORG PA50 dont give some any sound. I play but no sound come and I have test with beat I can see it works but no sounds . I think this is the problem : When you buy a keyboard you get standard sounds with the keyboard and I did something and now I dont got any standard sounds but I have my sounds I loaded in the pa50 but the problem is I THINK cause the keyboard not have standard sounds HOW CAN I FIX THIS PROBLEM ? HELP PLEASE
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Installing RAM on the keyboard is just like installing RAM in your typical computer. Unscrew the plates off the bottom of the keyboard and underneath you will find two parellel slots (usually beige colored) for the memory chips to go in. Simply place the memory chip in the slot. The memory chip has to to be a specific type of memory chip, does not take regular computer RAM. You can find specific kinds on sites such as ebay. Just type "Korg triton RAM" in the search bar.
I just changed the key on my Korg Triton Studio 61. It took some time, but it wasn't that hard. You'd better have a power screw driver. I had to take out at least 30 screws.
Do this at your own risk. Don't blame me if you mess up your keyboard. I'm telling you. If you're not that handy, don't try it. Pay attention to detail and be careful.
The Steps that I took
1) Turn your keyboard face down. Make sure you put it on something soft so that you don't scratch the face of your keyboard or damage your knobs or the pitchbender.
2) Remove all the screws on the bottom panel and remove the panel.
3) you have to take the entire keybed out. Lots of screws! I had to remove the "assignable - midi input/output board" to get it out. MAKE SURE THAT YOU DISCONNECT ANY CABLES THAT CONNECT THE KEYBED TO THE REST OF THE KEYBOARD. I had to disconnect the keybed at three different places. These connector cables are NOT strong and if you pull too hard, you WILL break them.
3) Once you get the keybed out, you have to remove the plastic binder that goes at the back of the keybed. It holds the keys in place.
Then Snap the old key out. snap the new key in. Before you unpack your new key, make sure the old one is really broken. I had a key that wasn't broken. It had just come unsnapped. I snapped it back in and it was fine.
Put it all back together again.
I had a broken key before. i got it repaired and it cost me $150. This time I fixed it myself and it cost me $7.50