Question about Logitech Harmony 880 LCD Remote Control

1 Answer

No signal leaving remote.

I've had my remote for several years woth no problems. All the sudden, it is like there is just no signal leaving the remote. Everything on the screen is responding like it's supposed to, even the little ican that shows it's putting a signal out. It's like the bulb is just not working, but that doesn't seem likely to me, I could be wrong. What would you suggest?

Posted by on

  • 2 more comments 
  • coryrw Feb 17, 2009

    The problem still existed when it shows a full charge, and didn't have any recent problems with it holding a charge.

  • Anonymous Feb 24, 2009

    Remote appears to charge normally but there's IR commands leaving the remote.

  • clykken Mar 03, 2009

    Everything seems normal but no devices can be controlled with the Harmony. I fully charged the battery and even reprogrammed the remote from my PC but have the same result. It would seem that the LED's aren't outputting but that seems unlikely.

  • Anonymous Mar 13, 2009

    No signal leaving remote



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 10,865 Answers

Sounds like the battery in the remote needs to be changed.

Posted on Feb 17, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Technician can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Technician (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Says no signal. What do I do

(Suddenly 2 largely different problems = Highly unlikely):You should verify that your set (non-remote) controls work at the set... and/or That your signal sources do/do-NOT work... because after that you will be either (or both): - ordering a remote or a remote board (pcb) and a new MAIN Board:
EBT62941306.Start by a full power removal for at least 5 minutes and retest... Failing that check out "tamptech" and noted below.I have written several procedures to get inside your set yourself.Good luck... work safe!

Yahoo Web Search

TV Parts Universal TV Stands DLP Chips ShopJimmy

I adore the last video...
1. it dispels the mystery of getting into the set.

2. He blows a circuit board... simply by NOT WEARING an ANTI-STATIC wrist strap.

Great viewing!

Comment me back if you wants SAFE suggestions. I DO NOT recommend beginners work on POWERED DEVICES...!!

Feb 07, 2016 | LG Televison & Video

1 Answer

My blinkers just all of a sudden stopped workin what could be the problem

Year, Make, Model, and Engine Size? This is always helpful as there are several hundred different cars that have. Any different ways of controlling the turn signals!

if they just stopped all of a sudden than the first thing I would do is locate the flasher. Check for power at the flasher if there is no power than start checking fuses. If there is power jump the flasher with a jumper wire and see if the turn signals come on (they will not blink) if they come on replace the flasher. If they do not come on than there may be an issue with the turn signal switch.

Mar 01, 2015 | Cars & Trucks

1 Answer

I have a MicroExpress laptop model FL92 that I bought several years ago. Ever since I got it, I've had problems with it suddenly quitting without warning. It appears to be heat-related and has p

depending how computer savey you are, you could open it up . clean heat sink and apply new thermal paste to the processor. not too moch, but not too little

Jan 30, 2013 | Computers & Internet

1 Answer

Philips TV 42PFL7403D/F7 Remote no longer controls Volume & ON/OFF

you can start with opening the remote control and clean the buttons on your remote control. don't use any aceton based products. there can be some grease on the buttons.
if you used the on/off and volume more then the other buttons.

Dec 19, 2017 | Philips Televison & Video

1 Answer

Nissan 1995 Sentra power windows and panel lights are dead. both power windows and panel lights suddenly went dead leaving the windows in up positionor also the radio does not work. I've change

I just answered your other question about this same issue. You need to stop replacing parts long enough to DIAGNOSE the problem so you are not creating further problems by changing all the parts on the car.

May 16, 2012 | 1995 Nissan Sentra

1 Answer

Dual handset ge 21008ge2-a handset needs registration suddenly came up for no reason. we've had the set for several years

Follow the registration instructions on page 15 of the manual at

Aug 18, 2011 | GE 21008GE2 Dual-Handset Cordless...

1 Answer

Hi, My Samsung UE46C8000 is suddenly showing left half of the screen fine, right half is simply colourful blurry vertical lines. After about 3 seconds the TV then restarts itself, but the problem...

if you have this tv connected to the internet try and see if it needs updating. it also could be the pip settinmg picking up an air signal instead of a cable channel.

Jun 25, 2011 | Televison & Video

1 Answer

I have a cablevision remote (ur2-cbl-cv04). Everything has been working fine. All of a sudden the green DVR button does not function as well as the Live button and a couple others. I rebooted the cable...

For the love of god, do NOT listen to Paul Sager - HDMI is *always* better than component. HDMI is a pure digital signal, offering the cleanest possible signal you can offer an HDTV. Component wiring is analog, and while good, it is by no means as good as HDMI.

Dec 19, 2010 | Bose Additional Wave radio II remote...

1 Answer

Can't find the radar signal

Please see this link for more info on this problem:

- Jim

Sep 06, 2009 | Garmin Nuvi 660 GPS Receiver

Not finding what you are looking for?
Logitech Harmony 880 LCD Remote Control Logo

Related Topics:

264 people viewed this question

Ask a Question

Usually answered in minutes!

Top Logitech Televison & Video Experts

The Knight
The Knight

Level 3 Expert

74666 Answers

Jerry Umali

Level 3 Expert

979 Answers


Level 3 Expert

1162 Answers

Are you a Logitech Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides