- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you need to replace both convergence ICs and the six 1 watt feed resistors. The ICs are both STK392-110 and the resistors you need one of each RK42 3.3 ohm 1watt, RK46 1.8 ohm 1watt, RK50 2.7 ohm 1watt, RK54 1.5 ohm 1watt, RK58 3.9 ohm 1watt and RK62 2.2 ohm 1 watt.
You can get replacement ICs and resistors at the following link with free instalation instructions. http://servicemanuals.vstore.ca/
If the Blue lines are blurs or shadows, then your Convergence IC's are going or gone bad. I have the same TV - it will be 4yrs. old in Dec. Mine started with Blue lines & shadows, then Red, Blue, Green Shadows. This is caused from over heating. The Convergence IC's have to be replaced. I have had 3 TV Repair shops all quote me a price from $350. to $400. to repair. They all said 4 years is the usual life time for these IC's. Replace the STK932-110amps with STK394-250-E or STK392-150 for greater reliability. Use only Original Replacement Parts, there are some cheaper but won't last and can't take the heat. If you are a "do-it-yourselfer" here is a link with the directions and pics. http://home.earthlink.net/~oleg.filippov/ConvergenceFix.htm Good Luck!
This would apear to be a convergence issue ..sometimes you can go into settings and converge it manualy.. if this is to far out of range. a service tech will have to adjust inservice mode. if the convergence cuircits are not failing. if so then there are cuircits that will have to be replaced. is this just a blue shadow?.. is there green or red shadows. if not it may not be a major repair.
Once in the Didigtal Array screen, can you move the red in that corner horizontally and vertically? You should be able to do this with the remote control, no special tools needed for this model. If you can't move it then you will need to replace your convergence output IC's they are location numbers IK04 and IK05 and are usually generic part numbers STK392-110.