Won't work say's clean

It's worth what you paid for it. If you found it, then with no brakes and probably repainted (which is why you have only the serial number) it's not worth much at all.

I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

put number 1 cylinder at top dead center and drop in distributor so the rotor points to number 1 on cap. may have to try several times as gear moves when lowering dist.

You either have a windshield leak & water in the
delayed relay & or the GEM Module failed

If only the lights are effected & not the radio,
blower,interior lights- the the GEM is most likely
okey

Then you trouble shoot the main problem

Try Google There is an overwhelming amount of ford
problems you can read

ereplacement parts type in your model number look over schematic and part should be identified with material num

You will need to replace the water inlet valve. Here is the part you need.

Did you try to remove the back cover after unplugiging your dryer ,to find a lot of lint in the back of the dryer? Some times you may have to clean in this area for fire safety. Maybe this would sold your problem.

if your hazard lights stay on, you may have a problem with the hazard switch on your stearing collum. try moving it back & forth several times, eg. on, off, on, off always ending @ off & see if that works. they do get sticky @ times. your brake lights will work but your turn signals won't work properly with the hazard switch turned on. let me know if problem persists & will see if i can help you more. good luck.

Based on your description of the problem you're experiencing, it sounds like you most likely pressed the "NUM LOCK" key. If NUM LOCK was activated before you cleaned the keyboard and was accidentally pressed during cleaning, this key press would deactivate NUM LOCK, causing the number pad to stop responding. To reverse this, simply press NUM LOCK again. The NUM LOCK button is located right above the "7" key on the number pad (see picture below).



Alternatively, since the setting determining whether NUM LOCK is activated when your computer is started is stored on your hard drive, you can try restarting the computer to revert back to an active NUM LOCK. Be sure to try this in case the first solution above does not work.

If you found this solution helpful, please leave a positive rating!

Gas valve PART NUMBER: 9761959

$108.58

In stock
Qty:

A used body control can be used in a vehicle other than the vehicle it was installed in. the body control module when first installed is programmed with the vehicle vin number. the vin number can not be changed was it was written to the BCM. the oprions can be always change in the BCM but not the VIN number. basically the used bcm you have installed has the vin number from the vehicle was installed in, now the vin number in the used BCM doesnt match all the other control modules