Pansat 2500a Dish Network Key

Each TV receiver has to be fed with a separate cable from the lnb. They can not be bridges or split.

Kbox Prodigy user Manual ZetaSat com

If your remote is a learning remote (has a little black glossy square on the top left side of the remote) you don't need a code, you just need the original remote. Place both remotes on a table, or other flat, sturdy surface, with the original TV remote facing the square on the DISH remote. Make sure both remotes have functioning batteries. On the DISH remote, hold down TV until the button blinks three times, then hold down record (for 5+ seconds) until the TV button lights up and stays on. Then, slowly, for each key you want to use, hit the key on the DISH remote (TV light blinks) then the corresponding key on the original remote (TV light blinks). For example: DISH Volume Up, TV remote Volume Up. When you are done learning all the keys you want to train, hit SAT. The TV light will blink three times, then the SAT light will light up for a moment. Try the DISH remote on your TV functions.

hi
try to find it on Google

To program your DISH Network remote to your Sony TV you will simply- press and hold the TV Mode button until all the other mode button back lights illuminate, then release.

-Now while the TV mode button is blinking please enter in the remote code 500 which is the remote code for your Sony TV after entering 500 then press the pound (#) key.

-After pressing the # key on the DISH Network remote, the TV mode button should blink 3 times and then turn off completely. This will mean the programming of the DISH remote to your TV has been completed successfully. While still in TV mode try any of the functions on the remote, such as turning the volume up or down on your TV or attempting to press the power button.

-The DISH Network remote should now be programmed to control your TV.

-If the remote code 500 doesn't program the DISH Network remote successfully you can also try each of the following using the same procedures, 000, 590, 640, 502, 002, or 567.

I hope this resolved the issue for you! Please feel free to contact us if you need any additional assistance.
-Kirstie DISH Network

Refer to page 82 in your Dish Network User's Guide......(Make sure Sony system is powered on and in DVD mode with a disc in the player).  Point Dish remote at Sony box -  Hold Aux until all buttons light up at top....press 2 - then STAR button* and then POWER button - then press the up arrow key repeatedly until Sony turns off - press # key to lock in code.
It took me awhile to get it to work....it will only work power, mute, and volume - not dvd play functions. Refer to page 85 to make the Dish remote control the Sony box volume by default.
Good luck.

i need codes for pansat 2500a

Dish Network (0101)
Key 1: 02 5A 2E 09 C9 B6 CD 1C A6 FA AF 34 8D 2B CE 79
Key 2: 4F C1 6C 53 93 15 D3 11 B0 E9 F5 15 35 52 86 04
Dish Network (0106)
Key 1: 04 AD BD 42 87 73 73 64 1F 4A 1F 41 55 4C 4B 69
Key 2: FF 14 A5 BE DA 7B D9 99 73 E3 06 85 34 69 22 45

I would suggest to go here to get a lot more info on how to program this receiver.

You need a new code. Check your signal strength under that installation section